User manual POULAN PRO PP25E

[. . . ] R ENGLISH Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. www. poulan-pro. com 1-800-554-6723 Instruction Manual Manual de Instrucciones Manuel d'Instructions PP25E ESPAÑOL For Occasional Use Only WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. [. . . ] It is designed to cut grass. DEPTH ADJUSTMENT KNOB BLADE The DEPTH ADJUSTMENT KNOB is used to adjust the wheel for blade cutting depth when edging. The BLADE is designed to cut sod. BEFORE STARTING ENGINE FUELING ENGINE when refueling. WARNING: Be sure to read the fuel information in the safety rules before you begin. If you do not understand the safety rules, do not attempt to fuel your unit. WARNING: Remove fuel cap slowly ON/STOP Switch HOW TO START YOUR UNIT To obtain the correct oil mix ratio, pour 3. 2 ounces of 2- cycle synthetic oil into one gallon of fresh gas. This engine is certified to operate on unleaded gasoline. Before operation, gasoline must be mixed with a good quality synthetic 2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. Poulan/WEED EATER brand synthetic oil is recommended. Mix gasoline and oil at a ratio of 40:1. A 40:1 ratio is obtained by mixing 3. 2 fluid ounces (95 ml) of oil with 1 gallon (4 liters) of unleaded gasoline. DO NOT USE automotive oil or marine oil. When mixing fuel, follow instructions printed on container. Once oil is added to gasoline, shake container momentarily to assure that the fuel is thoroughly mixed. Always read and follow the safety rules relating to fuel before fueling your unit. CAUTION: Never use straight gasoline in your unit. This will cause permanent engine damage and void the limited warranty. HELPFUL TIP WARNING: Avoid any contact with the muffler. A hot muffler can cause serious burns. Starting position If your engine still does not start after following these instructions, please call 1- 800- 554- 6723. Move the start lever to the START position. Primer Bulb HELPFUL TIP STARTING A COLD ENGINE NOTE: DO NOT squeeze the throttle trigger FUEL REQUIREMENTS IMPORTANT This engine requires the use of minimum 87 octane [R+M]/2 clean gasoline. Use of alcohol blended fuels (called gasohol or using ethanol or methanol) can cause major engine performance and durability problems. HOW TO STOP YOUR UNIT WARNING: Alternative fuels (not gasoline) such as E- (15% alcohol), E- (20% -15 -20 alcohol), E- (85% alcohol) are NOT classified -85 as gasoline and are NOT approved for use in 2-stroke gasoline engines. Use of alternative fuels will cause problems such as: improper clutch engagements, overheating, vapor lock, power loss, lubrication deficiency, deterioration of fuel lines, gaskets and internal carburetor components, etc. Alternative fuels cause high moisture absorption into the fuel/oil mixture leading to oil and fuel separation. Start Lever S Release the throttle trigger. S Push and release the engine ON/STOP switch. The switch will automatically return to the ON position. [. . . ] Poulan PRO recommends that you retain all receipts covering maintenance on your small off-road engine, but Poulan PRO cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. As the small off-road engine owner, you should be aware that Poulan PRO may deny you warranty coverage if your small offroad engine or a part of it has failed due to 20 abuse, neglect, improper maintenance, unapproved modifications, or the use of parts not made or approved by the original equipment manufacturer. You are responsible for presenting your small off-road engine to an Poulan PRO authorized repair center as soon as a problem exists. Warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days. [. . . ]