User manual POULAN PRO PPG6000

[. . . ] Portable Electric Generator Service Manual Model: PPG6000 Contents Chapter 1 General Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-7 General Description of Generator. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Safety Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Model Parameters. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Rolling them on a flat surface will help to check if they are bent. 8. Remove the rocker arm bolts so you can remove the rocker arm guide plate and inspect the plastic inserts in the plate for damage. Torque of the rocker arm bolt is 24N*m, 210 in*lbf 9. Inspect the flute and the protruding parts of the rocker arm. When tightening the 4 head bolts use an across the head sequence. Torque of the head bolts is 34N*m, 300 in*lbf 11. Remove the head and inspect the head gasket. Sometimes the head may need a tap up with a plastic hammer. Never use a screwdriver between the head and the cylinder or you will damage the surface. Fill the inlet and exhaust with cleaning fluid from the parts washer and look for leaks around the valves. If there are leaks the valves will need to be lapped and inspected. Do not gouge the head surface this will cause a hot spot and melt the head. Make sure you have on your eye protection. Remove the spring retainer clips from the valve springs. Holding the valve up and using a pair of pliers push down on the retainer. At the same time slide the retainer towards the larger hole and slowly let the retainer up. Inspect the valve guide inner diameters. The value for the diameter is listed in section 1. 1 tolerance parameters table. Never reuse the guides after they have been pressed out. Use a vernier caliper to measure the width of the inlet and exhaust valve seat. Width of seat: std value 1. 1mm up to 2. 0mm, . 043" to . 079" 18. The values are found in section 1. 1 tolerance parameters table. Measure the distortion value of the valve stem end with a micrometer following the 1 and 2 position in the figure. [. . . ] BOLT M6X12 DRAIN HOLE GROMMET Carburetor Assembly Description CARBURETOR ASSY Breather Assembly Description TUBEASSY, 3. 5X65 WIRE HARNESS CLIP CARBURETOR INSULATOR CARBURETOR PAKING A CARBURETOR PAKING B AIR CLEANER PACKING Flywheel Assembly Description COOLING FAN STARTER PULLEY COMP. FLYWHEEL NUT, M16 Ignition Coil Assembly Description IGNITION COIL ASSY. BOLT, M6X27 Quantity 1 1 1 2 1 1 2 1 1 1 1 3 Quantity 1 1 6 1 Quantity 1 Quantity 1 1 1 1 1 2 Quantity 1 1 1 1 Quantity 1 2 No. 182 178 177 179 176 176-1 176-2 180 216 181 No. [. . . ]