User manual POULAN PR17H42STD

[. . . ] Only allow responsible adults, who are familiar with the instructions, to operate the machine. Clear the area of objects such as rocks, toys, wire, etc. , which could be picked up and thrown by the blade. Be sure the area is clear of other people before mowing. Do not mow in reverse unless absolutely necessary. [. . . ] · The engine should not start unless the clutch/brake pedal is fully depressed and attachement clutch control is in the disengaged position. · When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine. · When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine. · The attachment clutch should never operate unless the operator is in the seat. BLADE CARE For best results mower blades must be kept sharp. Replace bent or damaged blades. 5/8" BOLT OR PIN BLADE BLADE REMOVAL (See Fig. 11) · · · Raise mower to highest position to allow access to blades. Remove hex bolt, lock washer and flat washer securing blade. Install new or resharpened blade with trailing edge up towards deck as shown. FIG. 12 BATTERY Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life. · Keep battery and terminals clean. · Remove hex bolts from blower housing and lift housing off engine. · Cover oil fill opening to prevent entry of dirt. · Use compressed air or stiff bristle brush to thoroughly clean engine cooling fins. · To reassemble, reverse above procedure. HEX BOLTS BLOWER HOUSING HEX BOLTS TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE FIG. 13 NOTE: Although multi-viscosity oils (5W30, 10W30 etc. ) improve starting in cold weather, these multi-viscosity oils will result in increased oil consumption when used above 32°F. Check your engine oil level more frequently to avoid possible engine damage from running low on oil. Change the oil after every 50 hours of operation or at least once a year if the tractor is not used for 50 hours in one year. Check the crankcase oil level before starting the engine and after each eight (8) hours of operation. Tighten oil fill cap/ dipstick securely each time you check the oil level. 13 and 14) Determine temperature range expected before oil change. All oil must meet API service classification SF-SJ. [. . . ] New Power Train Components incorporated in equipment used for commercial purposes are warranted in the same manner and to the same extent EXCEPT such Power Train Components are warranted for NINETY (90) DAYS ONLY, and must be received by Tecumseh or by a Tecumseh Authorized Service Outlet for such examination within 90 days from the date of sale to the original purchaser. New Power Train Components Incorporated in equipment used for rental purposes are warranted in the same manner and to the same extent EXCEPT such Power Train Components are warranted for THIRTY (30) DAYS ONLY, and must be received by Tecumseh or a Tecumseh Authorized Service Outlet within 30 days from the date of sale to the original purchaser. B. Alterations or Modifications of Power Train Components. Accidents, Normal Maintenance, Failure to follow the Original Equipment Manufacturer's Manual. [. . . ]