User manual POWERFIX KH 3006 360° LINE LASER

[. . . ] · If you do not intend to use the laser appliance for an extended period, remove the batteries. · Always change all batteries at the same time and always use batteries of the same type. · Clean the battery compartment with a dry cloth. · No liabilty will be accepted for damage resulting from manipulation to the laser equipment as well as from disregarding these safety instructions. Intended use This laser appliance contains a Class 2 Laser. [. . . ] Secure the rotating plate y to the wall in that you take both fastening pins i from the sides of the appliance and you press them through the fixing points on the rotating plate a and into the wall (See Fig. Notice: The fastening pins i can be inserted into most upper surfaces, such as wood, plaster or mortar. Alternatively, especially with other upper surfaces, you could also use adhesive tape for securing the rotating plate y. You can also secure the laser appliance q without the rotating plate, in that the fastening pins i are inserted through fixing points on the laser appliance o itself. Place the laser appliance q onto the rotating plate y. Turn the laser appliance q with the marking arrow u into the desired direction. Switch the laser appliance q on, by pressing the ON/OFF button w. The laser beam appears on the wall in the direction of the marking arrow u. Inserting the batteries 1. Insert two batteries of Type AAA/LR03 into the battery compartment s. Comply with the polarity markings in the battery compartment s. Close the battery compartment s. Utilisation Switching On and Off 1. To switch the laser appliance q on, press the ON/OFF w button. To switch the laser appliance q off, press the ON/OFF w button once again. Plumb-line To mark a plumb-line, turn the laser appliance q on the rotating plate y with the marking arrow u pointing in the direction in which the laser marking is to be indicated, then finely adjust it vertically with the spirit level r. Utilisation on a wall 1. Remove the laser appliance q from the rotating plate. The laser appliance clings to the rotating plate y magnetically. Place the rotating plate y at the position on the wall from where you wish to draw the alignment line. -2- Horizontal line To mark a horizontal line, turn the laser appliance q on the rotating plate y with the marking arrow u pointing in the direction in which the laser marking is to be indicated, then finely adjust it horizontally with the spirit level e. Important: The air-bubbles in the spirit levels e+r must be positioned between the two markings. Storage · Keep the fastening pins i in the recesses provided on the sides of the appliance. · If you are not going to use the appliance for a long period, remove the batteries from the battery compartment s and store them seperately. Disposal Do not dispose of the appliance in your normal domestic waste. Dispose of the appliance through an approved disposal centre or at your community waste facility. Observe the currently applicable regulations. [. . . ] Under no circumstances should the laser appliance q be submersed in water or other fluids. The appliance could be irreparably damaged. Do not use aggressive detergents or solvents. They could cause damage to the appliance. [. . . ]