User manual POWERFIX KH 3322

[. . . ] Read the operating instructions carefully before using the appliance for the first time and preserve this booklet for later reference. Pass this manual on to whoever might acquire the appliance at a later date. Warning about an area of risk Earthing Should this product be used in a manner that is not described here, under certain circumstances its built-in safety protections could be impaired. Repairs may only be carried out by the manufacturer, his Customer Service or a similarly qualified person. [. . . ] If the device is not to be used for an extended period, the battery must be removed to avoid potential damage caused by it possibly leaking. Indicator for automatic measurement range selection Indicator for diode testing Indicator for continuity testing Indicator for retained measurement values Indicator for measurement difference Indicator for light measurement in Lux x 10 Indicator for light measurement in Lux Indicator for sound (dB) and air humidity measurements (%RH) Indicator for temperature measurements Indicator for resistance (k, M, ) and frequency measurements (Hz) Indicator for condenser (n-, µ-F), current (A) and voltage measurements (V) Numeric display Indicator for weak battery Indicator for negative voltage Indicator for alternating current Indicator for direct current During the course of measurement, press the button HOLD t to retain the measured value in the display z so that it is available after the measurement. To quit the HOLD indicator, press the button HOLD t once again. To quit the REL indicator, press the button REL 5 once again. Always remove the measuring leads from the object being tested before switching over to a new function or a different area of measurement. The device may only be used in a dry and clean environment. Dirt and moisture diminish the insulation resistances and this could, especially with large voltages, lead to you receiving an electric shock. The device may only be utilised within the given measurement ranges. Before being taken into use, the device must be tested for correct functioning (e. Steps are to be taken to ensure that the measuring leads are in a faultless condition. If the object being tested is not correctly connected to the multimeter with the regard to polarity, the indicated measurement value is preceded by a minus sign. With component measurements, the component being tested may not be located within a switching, as this would falsify the measurement results. Should this limit be exceeded, there is a risk of both damaging the device and an imperilment of the user. Disconnect the measurement prods from the object being tested before selecting a different area of measurement. Connect the measurement prods with the object being tested. Press the button RANGE e once to switch from the automatic to the Press the button RANGE e once again to show the various measurement conclusions, one after the other. Subject to the fed voltage, the display of the measurement conclusions begins with one of the following indicator formats: -> Measured value in Millivolt (mV) with one decimal place -> Measured value in Volt (V) with three decimal places -> Measured value in Volt (V) with two decimal places -> Measured value in Volt (V) with one decimal place -> Measured value in Volt (V) without decimal places After this, the display of measurement conclusions starts again from the beginning. To switch back to automatic measurement conclusions, hold the button RANGE e pressed down for approx. In this case, enter in a higher measurement conclusion. With open measurement prods and an automatic measurement conclusion, a vacillating measurement conclusion appears in the mV range, resulting from the high input sensitivity. During the actual measurement a stable and correct indication is given. Before attachment of the measurement leads, the object being tested must be de-energised, so as not to damage the device or the object being tested. [. . . ] In this case, enter in a higher measurement conclusion. If the device is utilised as per the operating instruction, it does not require any further special maintenance. Should the device become soiled through daily use, it can be cleaned with a dry or slightly moist cloth. Do not dispose of the device in your normal domestic waste. [. . . ]