User manual POWERFIX KH 710 DRAIN CLEANER

[. . . ] This appliance is intended for domestic use only, do not use it for commercial or industrial applications. Remove all loose parts, for example particle sieves, from the bowl and seal all openings on the same pipe, for example overflows, with a wet cloth or something similar. This will avoid soiling from the sprays which may be generated by the compressive splice. [. . . ] Close and seal all openings, for example overflows, on the pipe to be cleared. use the overflow seal for the overflows 0: · With round overflows, press and hold the roll pin so that the locking lever can be flapped in such a way that it stands in extension with the roll pin (Fig 1). Turn the roll pin through 90° and slowly release it (Fig. As soon as the locking lever hits against the rear wall, it opens itself out (Fig. If the overflow seal 0 cannot close the overflow, use a cloth or something similar to seal it. Use this appliance only on drains and pipeworks able to withstand pressure. Support poorly seated pipes against the floor!If you do not, the pressure surge could damage the pipe. Close the plughole with a stopper and and pour some warm water into the bowl (up to about 7 cm above the plughole). The best possible pressure effect is achieved only when the blocked pipe is completely filled with water. Without water in the pipe the pressure effect is strongly reduced. Build up a little pressure by pressing the pump 3 3-4 times. Remove the appliance from the water and press the pump 3 about 10 times. Should you wish to release some pressure from the appliance, unscrew the air release valve 1. Place the appliance back onto the plughole and activate the pressure surge. Repeat these pressure surges only for as long as the water level is above the plughole. [. . . ] After frequent usage it could happen that the pump 3 may require lubrication: 1. Insert a few drops of silicon oil into the handgrip. Other oils could damage the seals or the plastic. [. . . ]