User manual POWERFIX KH 2910

[. . . ] Safety notices Intended purpose Description Items supplied Overview Technical data Placing furniture on the roller bases Shunting furniture Removing the roller bases Troubleshooting Cleaning Storage Disposal Importer/Service Declaration of conformity Read the operating instructions carefully before using the appliance for the first time and preserve this booklet for later reference. Serious injuries caused by the tipping of loads are possible. Ensure that the load to be shunted cannot tip over. [. . . ] Ensure that there are no obstacles in the way on the shunting route. Only use the furniture transporter with four roller bases on level surfaces. The furniture transporter with four roller bases is only suitable for shunting furniture over short distances. With the help of the furniture transporter you can lift pieces of furniture and place them on the roller bases. Subsequently, you can shunt the furniture over short distances with a minimum of effort. Immediately after unpacking check to ensure that all components are available and that there are no signs of visible damage to the furniture transporter with four roller bases: · 1 Lever arm with swivelling head · Remove the contents from furniture pieces before lifting and shunting them. Always slide the swivel head of the lever arm under the furniture to the stop plate. Ensure that there is sufficient space available to To lower the furniture piece onto the roller base To avoid an irregular elevation, always place the lever arm in the middle of the side to be lifted. at the hand grip · With this you will require the least effort. Push the swivelling head ¿ of the lever arm under the furniture and in the middle of it (A). To lift the furniture, slowly press the lever arm down (B). Repeat the above procedure for the opposite Pull/push the furniture piece to the desired location with the assistance of the roller bases . The furniture piece is very difficult to shunt. To avoid an irregular elevation, always place the lever arm in the middle of the side to be lifted. [. . . ] observe the currently applicable regulations. In case of doubt, please contact your waste disposal centre. We, Kompernaß Handelsgesellschaft GmbH, Burgstraße 21, D-44867 Bochum declare on our own responsibility, that the product Furniture Transport Set Typ KH 2910 conforms with all requirements of the Machine Guidelines: 2006/42/EC. [. . . ]