User manual POWERFIX PBMP 30 A1

[. . . ] The pump may not be used if it shows signs of damage. The drive shaft of the pump does not allow itself to be turned by hand. This does not indicate that the pump is defective. € Use only hoses certified as being able to withstand a pressure of at least 3 bars (44 psi). [. . . ] Let the drill u start to run in a clockwise rotation and at low revolutions and then guide the pump q straight onto the drive shaft e. The drive shaft e is thereby secured to the pump q. Attach the suction hose to the connection o and the pressure hose to the connection a. Pay heed to the direction of flow detailed on the pump q. When using a chuck with SDS fitting and the long drive shaft r. µ Attach the long drive shaft r into the chuck. µ Insert the electric drill u, with the pre-assembled drive shaft r in the chuck, into the mounting y. µ Tighten the cross-headed screw on the mounting y firmly, so that the drill u µ Now push the pump q onto the mounting y so that the drive shaft r µ µ projects into the thread of the drive shaft w and the pins of the mounting y are located in the reception holes on the pump q. Allow the electric drill u to run with a clockwise rotation and low revolutions and guide the pump q straight on to the drive shaft r. With this the drive shaft r will be fixated onto the pump q. Attach the suction hose to the connection o and the pressure hose to the connection a. Pay heed to the direction of flow detailed on the pump q. 2012 12:08 Uhr Seite 37 Disassembly of the drive shaft Disassembly of the short drive shaft e Wheel rim chuck µ Open the chuck with the chuck key through the recess i and then remove the pump q from the mounting y. µ Unscrew the short drive shaft e by using a cross-headed screwdriver and the open-ended spanner from the pump q. µ Using the open-ended spanner through the recess i, counter screw the µ Allow the electric drill u to run with an anti-clockwise rotation and low reµ Remove the pump q from the mounting y. µ Remove the drive shaft e from the chuck. The drive shaft e is thereby released from the pump q. Quick-release chuck Disassembly of the long drive shaft r Chuck with SDS fitting µ Using the open-ended spanner through the recess, i counter screw the drive shaft w of the pump q. µ Allow the electric drill u to run with an anti-clockwise rotation and low revolutions. With this the drive shaft r will be released from the pump q. [. . . ] Only in this way can a post-free despatch for your goods be assured. The warranty covers only claims for material and manufacturing defects, but not for transport damage, for wearing parts or for damage to fragile components, e. This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. [. . . ]