User manual PRECISION POWER S200.2

[. . . ] PRECISION POWER HAS ABSOLUTELY NO LIABILITY FOR ANY AND ALL ACTS OF THIRD PARTIES INCLUDING ITS AUTHORIZED DEALERS OR INSTALLERS. BY PURCHASING THIS PRODUCT, THE CONSUMER AGREES AND CONSENTS THAT ALL DISPUTES BETWEEN THE CONSUMER AND PRECISION POWER SHALL BE RESOLVED IN ACCORDANCE WITH CALIFORNIA LAWS IN LOS ANGELES COUNTY, CALIFORNIA. Some states do not allow limitation on how long an implied warranty lasts. In such states, the limitation or exclusions of this Limited Warranty may not apply. [. . . ] Step 6: There are two sets of connections on the crossover. The input terminals (IN) should be connected to the source (radio or amplifier). The woofer terminals (W) should be connected to the midrange speaker. The tweeter terminals (TW) should be connected to the tweeter. Be sure to observe the correct polarity. Changing the polarity of the tweeter may be necessary for optimum sound quality. Step 7: Re-install the crossover cover. INTRODUCTION Thank you for your purchase of this Sedona Series Component Loudspeaker System from PrecisionPowerTM. Our engineers have combined state of the art materials such as formed prolypropylene cones and mylar dome tweeters with cutting edge industrial design to achieve competition-ready performance levels. Continuous exposure to sound pressure levels over 100dB may cause permanent hearing loss. High power automotive sound systems can generate sound pressure levels in excess of 130dB. When playing your system at high levels, please use hearing protection and prevent long term exposure. Step 4: If not using a hole saw, use either the cardboard packaging for the tweeters or the surface mount trim ring as a template to mark the proper size hole. Step 5: With the tweeter assembled, route the wires through the hole and the pressure ring and slip the pressure ring over the tweeter assembly. Step 6: Align the tweeter so the logo faces the desired direction then push the pressure ring on to the rear of the tweeter assembly until the tweeter is snugly mounted to the panel. Step 7: Connect the speaker wires observing the correct polarity and re-assemble the panel. DOOR MOUNTING When considering possible speaker locations in the doors, be sure to check the operation of the window mechanism and all other moving parts inside the door. Most vehicles use a stabilizer stop bar in between the door and the door jamb. This bar prevents the door from opening too far, but may intrude into the speaker mounting area when the door is closed. Many do-it-yourself installers overlook this and check for speaker clearance only when the door is fully open. REAR DECK MOUNTING In rear deck installations, check the operation of the trunk suspension springs or tension bars. These tension bars can move when opening and closing the trunk and can exert a great deal of force against anything that obstructs their movement, such as a speaker basket or motor assembly. In addition, try to avoid locating the speakers too close to the back edge of the rear deck. Installing the rearmost screws may not be possible without the removal of the rear window. [. . . ] Make sure to keep wires away from sharp metal or other edges. When passing through metal, use a protective grommet. Step 6: Turn the speaker backwards against the surface & mark the mounting holes with a pen. Step 7: Pre-drill mounting holes using a 1/8" drill bit. [. . . ]