User manual PRESIDENT HARRISON

[. . . ] AM BLU BF CB CH CQ CW DX DW FM GMT GP HF LSB RX SSB SWR SWL SW TOS TX : : : : : : : : : : : : : : : : : : : : : Amplitude Modulation (modulation d'amplitude) Bande latérale unique Basse fréquence Citizen Band (canaux banalisés) Channel (canal) Appel général Continuous waves (morse) Liaison longue distance Dual watch (double veille) Frequency modulation (modulation de fréquence) Greenwich Meantime (heure du méridien de Greenwich) Ground plane (antenne verticale) High Frequency (haute fréquence) Low Side Band (bande latérale inférieure) Receiver (récepteur) Single Side Band (Bande latérale unique) Standing Waves Ratio Short waves listening (écoute en ondes courtes) Short waves (ondes courtes) Taux d'ondes stationnaires Transceiver. Before using, be careful never to transmit without first having connected the antenna (connection "B" situated on the back panel of the equipment) or without having set the SWR (Standing Wave Ratio) !Failure to do so may result in destruction of the power amplifier, which is not covered by the guarantee. The guarantee of this transceiver is valid only in the purchase country. [. . . ] Suppresses undesirable back-ground noises when there are no communication. Squelch does not effect neither sound nor transmission power, but allows a considerable improvement in listening comfort. A) ASC: Automatic Squelch Control Worldwide patent, a PRESIDENT exclusivity No repetitive manual adjustment and a permanent improvement in listening comfort when this function is active. It can be disconnected by turning the switch (2) clockwise, in this case the manual squelch control becomes active again. B) Manual squelch Turn the squelch knob clockwise to the exact point where all back-ground noise disappears. This adjustment should be done with precision as, if set to maximum, (i. To access channel in the memory button, simply press the "R/ M" button, and then "M" will appear at the right side on the LCD. Press the memory button you want to access. Your desired channel number should appear on the LCD with the corresponding memory button. B) MEMORY : This feature is used to memorise your most frequently used channels, allowing immediate access to them in a very convenient, simplistic method. Your HARRISON has seven user selectable memory channels. You may program any channel into memory. If you desire to change the channel being stored within a memory button, simply repeat the process described above. The new channel number will be stored over the channel that was previously in that memory button. Simply press "PWR" button to turn on the C. A) FUNCTION : This button, when used in conjunction with the buttons on the front panel, allows access of the function of each button. The HARRISON comes with the first function of each button. when you turn on the radio "SCAN , AUTO-Q , MON , BEEP , EMG" will appear on the LCD. To access the second function of each button, press the "M1" button once again. Then "BATT, DW, LOCK" will appear at the bottom line on . B) MEMORY 1 : This button is used to store the channel you want at memory mode. The state-of-the art liquid crystal panel provides the user with visual information center on the operation and status of the HARRISON To access, press "M1" button until "BATT, DW, LOCK" will appear at the bottom line on the LCD. [. . . ] When receiving a weak signal, push and hold this button to open the squelch completely. To access, press "M1" button, then "SCAN, AUTO-Q, MON, BEEP, EMG" will appear at the bottom line on the LCD Then press "M5" button, "BUSY" will appear on the LCD. B) LOCK : The Lock feature allows the user to "lock" virtually all buttons on the radio, so they can not be activated. This will prevent the radio from having its operation mode changed from the one desired by the user. [. . . ]