User manual PRESIDENT HARRY

[. . . ] Power, antenna, accessory cabling) so that they do not in any way interfere with the driving of the vehicle. D) To install your equipment, use the cradle (1) and the self-tapping screws [2] provided (drilling diameter 3. Take care not to damage the vehicle's electrical system while drilling the dash board. E) Choose where to place the microphone support and remember that the microphone cord must stretch to the driver without interfering with the controls of the vehicle. [. . . ] Should it be necessary to lengthen the power cable, you should use the same or a superior type of cable. C) It is necessary to connect your CB to a permanent (+) and (-). We advise you to connect the power cable directly to the battery (as the connection of the CB cable to the wiring of the car-radio or other parts of the electrical circuit may, in somecases, increase the likelihood of interference). d) Connect the red wire (+) to the positive terminal of the battery and the black (-) wire to the negative terminal of the battery. E) Connect the power cable to your CB radio. E) Go to Channel 20 using the rotary knob on the front panel. Suppresses undesirable back-ground noises when there are no communication. Squelch does not effect neither sound nor transmission power, but allows a considerable improvement in listening comfort. A) ASC: Automatic Squelch Control Worldwide patent, a PRESIDENT exclusivity No repetitive manual adjustment and a permanent improvement in listening comfort when this function is active. It can be disconnected by turning the switch (2) clockwise, in this case the manual squelch control becomes active again. B) Manual squelch Turn the squelch knob clockwise to the exact point where all back-ground noise disappears. This adjustment should be done with precision as, if set to maximum, (i. WARNING: This must be carried out when you use your CB radio for the first time (and whenever you re-position your antenna). The adjustment must be carried out in an obstacle-free area. SWR 1 or SWR 2): a) To connect the SWR meter : - Connect the SWR meter between the CB radio and the antenna as close as possible to the CB (use a maximum of 40 cm cable, type President CA 2C). Meter should be as near as possible to 1. If this is not the case, re-adjust your antenna to obtain a reading as close as possible to 1. - It will be necessary to re-calibrate the SWR meter after each adjustment of the antenna. This knob is for adjusting sensitivity during reception. For long distance communications RF GAIN should be set to maximum. RF GAIN can be reduced to avoid distortion, when your correspondent is close by and who does not have the RF POWER function. Turning this knob allows you to choose a channel (1-40) for transmitting and receiving. [. . . ] you should receive a reply like , «Strong and clear». If you use a calling channel (19, 27) and you have established communication with someone, it is common practice to choose another available channel so as not to block the calling channel. Advertising Back off Basement Base station Bear Bear bite Bear cage : : : : : : : Flashing lights of police car Slow down Channel 1 A CB set in fixed location Policeman Speeding fine Police station Below you will find some of the most frequently used CB radio expressions. Remember this is meant for fun and that you are by no means obliged to use them. [. . . ]