User manual PRESIDENT JACKSON

[. . . ] D) To install your equipment, use the cradle (1) and the self-tapping screws [2] provided (drilling diameter 3. Take care not to damage the vehicle's electrical system while drilling the dash board. E) Do not forget to insert the rubber joints [3] between the CB and its support as these have a shock-absorbing effect which permits gentle orientation and tightening of the set. F) Choose where to place the microphone support and remember that the microphone cord must stretch to the driver without interfering with the controls of the vehicle. [. . . ] We advise you to connect the power cable directly to the battery (as the connection of the CB cable to the wiring of the car-radio or other parts of the electrical circuit may, in somecases, increase the likelihood of interference). d) Connect the red wire (+) to the positive terminal of the battery and the black (-) wire to the negative terminal of the battery. E) Connect the power cable to your CB radio. A) To turn the set on, turn the knob (1) clockwise b) To increase the sound level, turn the same knob further clockwise. Suppresses undesirable back-ground noises when there are no communication. Squelch does not effect neither sound nor transmission power, but allows a considerable improvement in listening comfort. A) ASC: Automatic Squelch Control Worldwide patent, a PRESIDENT exclusivity No repetitive manual adjustment and a permanent improvement in listening comfort when this function is active. It can be disconnected by turning the switch (2) clockwise, in this case the manual squelch control becomes active again. B) Turn the squelch knob clockwise to the exact point where all back-ground noise disappears. This adjustment should be done with precision as, if set to maximum, (i. WARNING: This must be carried out when you use your CB radio for the first time (and whenever you re-position your antenna). The adjustment must be carried out in an obstacle-free area. SWR 1 or SWR 2): a) To connect the SWR meter : - Connect the SWR meter between the CB radio and the antenna as close as possible to the CB (use a maximum of 40 cm cable, type President CA 2C). Meter should be as near as possible to 1. If this is not the case, re-adjust your antenna to obtain a reading as close as possible to 1. - It will be necessary to re-calibrate the SWR meter after each adjustment of the antenna. The mode must correspond with that of the person with whom you communicate. Lower and Upper Side Band is used for communications over long distances (depends very much on atmospheric conditions). S/RF position: View-meter indicates relative transmitter output power when transmitting and input signal strength when receiving. The View-meter shows the level of reception and the level of power emitted, as well as the modulation rate These filters allow the reduction of back ground noises, and some reception interferences. When you finish speaking and you release the «push-to-talk» switch to allow your correspondent to speak, a «beep» sounds. Radio CB is what is known as a «simplex» method of communication, that is to say, that you cannot listen and speak at the same time (as you can, for example, with the telephone). [. . . ] Release the switch and wait for a reply. you should receive a reply like , «Strong and clear». If you use a calling channel (19, 27) and you have established communication with someone, it is common practice to choose another available channel so as not to block the calling channel. Advertising Back off Basement Base station Bear Bear bite Bear cage Big slab Big 10-4 Bleeding Blocking the channel Blue boys Break Breaker Clean and green Cleaner channel and proud Doughnut Down and gone Down one Do you copy? [. . . ]