User manual PRESIDENT VALERY CLASSIC

[. . . ] Power, antenna, accessory cabling) so that they do not in any way interfere with the driving of the vehicle. D) To install your equipment, use the cradle (1) and the self-tapping screws [2] provided (drilling diameter 3. Take care not to damage the vehicle's electrical system while drilling the dash board. E) Do not forget to insert the rubber joints [3] between the CB and its support as these have a shock-absorbing effect which permits gentle orientation and tightening of the set. [. . . ] We advise you to connect the power cable directly to the battery (as the connection of the CB cable to the wiring of the car-radio or other parts of the electrical circuit may, in somecases, increase the likelihood of interference). d) Connect the red wire (+) to the positive terminal of the battery and the black (-) wire to the negative terminal of the battery. E) Connect the power cable to your CB radio. E) Go to Channel 20 using the rotary knob on the front panel. Suppresses undesirable back-ground noise when there are no communications. Turn the squelch knob clockwise to the exact point where all back-ground noise disappears. This adjustment should be done with precision as, if set to maximum, (i. Squelch does not effect either sound or transmission power, but allows for considerable improvement in listening comfort. An external loud speaker can be connected to your PRESIDENT VALERY by the jack plug situated on the back panel PA. By pressing the PA key, the message transmitted into the microphone will be directed towards the external speaker and be amplified. Hold the microphone far enough away from this loud speaker so as to avoid the Larsen effect. To increase the sound level, use the MIC GAIN knob. WARNING: This must be carried out when you use your CB radio for the first time (and whenever you re-position your antenna). The adjustment must be carried out in an obstacle-free area. SWR 1 or SWR 2): a) To connect the SWR meter : - Connect the SWR meter between the CB radio and the antenna as close as possible to the CB (use a maximum of 40 cm cable, type President CA 2C). Meter should be as near as possible to 1. If this is not the case, re-adjust your antenna to obtain a reading as close as possible to 1. - It will be necessary to re-calibrate the SWR meter after each adjustment of the antenna. This filter allow the reduction of back ground noise, and some reception interference. Move the switch once to activate the function. The modulation mode must correspond with that of the person with whom you communicate. A/ Amplitude Modulation (AM) is for communications in areas where there are obstacles and over medium distances. [. . . ] Remember this is meant for fun and that you are by no means obliged to use them. Emergency, you should be as clear as possible. Big slab Big 10-4 Bleeding Blocking the channel Blue boys Break Breaker Clean and green Cleaner channel Coming in loud and proud Doughnut Down and gone Down one Do you copy?DX Eighty eights Eye ball Good buddy Hammer Handle Harvey wall banger How am I hitting you? [. . . ]