User manual PRICE PUMP 3AOD-STTS-B

[. . . ] Price ® Pump Co. INSTALLATION, OPERATING AND MAINTENANCE MANUAL 3" AIR OPERATED DIAPHRAGM PUMPS METALLIC, BOLTED MODELS: 3 AOD-XXXX-B ALL ELASTOMERS PLEASE FILL IN DATA FROM YOUR PUMP NAMEPLATE Pump Model______________________ Spec. No. _________________________ Price ® Pump Company P. O. Box Sonoma, CA 95476 Tel: 707-938-8441 Fax 707-938-0764 Email: sales@pricepump. com Serial No. _________________________ RETAIN MANUAL FOR REFERENCE IN-AOD-300M-B rev. - Congratulations You are now the owner of a Price® Pump Co. This pump was carefully inspected and subjected to final performance tests before releasing for shipment. [. . . ] Assemble the pump chamber ( 1) to the air valve half (86) using twelve capscrews (9) flat washers (96). Torque each capscrew, using a "Cross-Sequence" to: IN-AOD-300M-B rev. - Page - 7 O P E R AT I N G I N S T R U C T I O N S 15 ft. Turn the unit over so that it is resting on the pump chamber (1) previously fastened. Repeat step #6 for the other side of the unit. Turn unit upside down so that it is resting on the discharge flange of the pump chamber (1) and the suction flange is facing up. Insert ball valve (29), "O"-ring (47), ball valve seat (28) and "O"-ring (47) into each suction port of the pump chamber (1). Check to make sure the surface of the "O"-ring is above the surface of the pump chamber flange. Fasten the suction manifold (24) to each pump chamber (1) using eight lock washers (53) and capscrews (52). Turn the unit right-side up so that it is standing on its feet. Place a ball valve (29), "O"-ring (47), ball valve seat (28), and "O"-ring (47) into each discarge manifold flange (23). Check to make sure the surface of the "O"ring is above the surface of the manifold flange. Fasten the discharge manifold (23) to each pump chamber (1) using eight lock washers (53) and capscrews (52). Note that the suction and discharge manifolds can be oriented to fit the installation requirements. bearings (43) without removing them from the air valve halves. If it becomes necessary to replace the sleeve bearings, they can be pressed out of each bore. The shaft seals can be removed by prying them out with a small screwdriver or similar blunt tool. Remove the mufflers (44) from each air valve half (86). Inspect the muffler for damage or any debris that may be trapped inside. Restrictions to air flow will adversely affect pump performance. Clean the mufflers thoroughly or replace with new. Clean any exposed passages to ensure complete and unobstructed air flow. [. . . ] THE FOREGOING S EXPRESS, IMPLIED AND STATUTORY, INCLUDING WITHOUT LIMITATION, THE IMPLIED, WARRANTIES OF MERCHANTABILITY AND FITNESS. ANY PRODUCT (S) SOLD HEREUNDER WHICH IS NOT MANUFACTURED BY SELLER ARE NOT WARRANTED BY SELLER and shall be covered only by the express warranty, if any, of the manufacturer thereof. With respect to products and parts not manufactured by Seller, Seller's only obligation shall be to assign to Buyer, to the extent possible, whatever warranty Seller obtains from the manufacturer. Upon Buyer's submission of a claim as provided above and its substantiation, Seller shall at its option either (i) repair or replace its product, part or work at the original place of shipment, or (ii) refund an equitable portion of the purchase price. [. . . ]