User manual PRO-JECT DEBUT CARBON PIANO

[. . . ] Never handle the power cord while your hands are wet or damp. Never place any item containing liquid, such as a flower vase on or near the device. Never place any naked flame sources, such as lighted candles on or near the device. The product shall not be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions. [. . . ] The earthing wire of the tonearm lead should be connected to the earth terminal on your amplifier (if provided). For detailed product information regarding Pro-Ject Audio interconnect cables please refer to the Pro-Ject web site www. project-audio. com. The recommended load impedance for the factory fitted cartridges is: 47kohms /MM-input The 3, 5 mm connector (supplied) can be used to connect your Pro-Ject Debut Carbon/Phono USB to any line level/auxiliary input (Computer, Midi System, Mixer etc. ). Connect the socket end to the phono plugs at the end of the audio trailing lead from your turntable and insert the 3, 5 mm plug into the relevant socket on your audio component. Connecting to a Computer Connect the USB-output of the unit to a free USB-socket on your computer and turn it on/make sure it is powered on. The “new hardware found assistant“ will automatically detect the unit and announces it as a Microphone USB audio codec. There is no need to install a driver manually. After installation, one setting has to be done. For example - Windows 7® operating system:  Control Panel  Sound  Recording  Microphone USB Audio CODEC  Properties  Advanced: set to 2 channel, 16 bit, 48000 Hz (DVD Quality) Please note: Connection should be made to an USB-socket of your computer directly. Connecting to USB-hubs or switches can cause problems. Recording Programme In case you do not have a recording programme installed on your computer, you may download one free from the Internet. Recording programmes may be found by searching Google or Yahoo. In the menu of the recording programme, source or input may have to be set to Microphone USB audio codec. Please be aware that downloads from the Internet are made entirely at your own risk. Under no circumstances can we carry responsibility or provide support for third-party software products sourced from the internet or for any damage or problems arising from the use thereof. All downloads should be checked with an up-to-date anti-virus programme. License fees may be applicable. Mains power connection Connect the mains lead to the mains. AC outlet voltages vary from country to country. voltage in your area meets the voltage requirements printed on a label underneath the unit. Useful tips The record player should be positioned on a low-resonance surface such as wood or multiple layer ply board to avoid structural vibrations disturbing replay. Switching on and off Pressing the power switch (19) alternately starts or stops the motor. © Audio Trade GmbH · Pro-Ject Debut Carbon/Phono USB / Ortofon OM10 · Revision 2013. 3. 15 5 Changing replay speed To play records at 45 r. p. m. Using the accessory tool provided (3a), hook the belt (3) over the larger diameter part of the motor pulley (2). repeat the proceedings using the smaller step on the pulley. When the Pro-Ject Speed Box SE is used speed change between 33 and 45 r. p. m. There is no need to move the belt manually. is available after fitting a special pulley, which may be purchased as an optional extra. [. . . ] Please remove these parts and pack them separately: lid (10), counterweight (6), anti-skating weight (16) platter (5) and belt (3). Insert the transport lock for the tonearm (18) prior to carefully packaging the record player. Warranty The manufacturer accepts no responsibility for damage caused by not adhering to these instructions for use and/or by transportation without the original packaging. Modification or change to any part of the product by unauthorized persons release the manufacturer from any liability over and above the lawful rights of the customer. Copyright, trademarks PRO-JECT is a Registered Trademark of H. The information was correct at the time of going to press. [. . . ]