User manual PROCOLOR DYNA SCREEN RF DATASHEET

[. . . ] 38 2 Contents Additional options . 42 Opening the "Settings" menu . 48 Faults in the water intake/water drain . 49 General problems with the dishwasher . [. . . ] Otherwise steam from the dishwasher could damage the edge of the counter top because the fan is no longer running. ^ Unload the dishwasher. Dishes tend to break and chip more easily when they are hot. Allow the dishes to cool until they are comfortable enough to handle before unloading them. 37 Use Interrupting a program A program is interrupted as soon as the door is opened. If the door is closed again, the program will continue from where it was interrupted. Changing a program If the detergent flap is already open, do not change the program. If a program has already started and you wish to change it: ^ Open the door. ^ Turn the dishwasher off with the K button. ^ Turn the dishwasher on again with the K button. ^ Start the program by closing the door. The program starts. , Water in the dishwasher is hot. Only open the door if absolutely necessary and exercise extreme caution when doing so. Before closing the door again, leave it ajar for approx. If you press and hold the , button, the time will automatically count up to 24 h. To start again at 30 minutes, press the , button twice. If, after you have set the delay start time, you do not close the door within a few seconds, the display will revert to showing the program duration. You will have to enter the delay start time again. The time will count down to the program start in 1-minute steps. Once the delay start time has elapsed, the selected program starts. The display shows the remaining time, the , indicator light goes out, and the indicator light of the selected program comes on. 40 Additional options Starting a program before the Delay start has elapsed: A program can be started before the Delay start time has elapsed. ^ Press the K button to turn the dishwasher off. ^ Press the K button to turn the dishwasher on again. ^ Start the program by closing the door. The optical control lights to confirm that a program has started. 41 Settings menu The "Settings" menu allows you to change standard settings Opening the "Settings" menu ^ Press the K button to turn the dishwasher off. [. . . ] See "Frequently Asked Questions" for more information. ­ If the water pressure is higher than shown, a pressure reducing valve must be used. Ensure that the water connection is secure after the first use. , Installation, repairs and other work , Do not drink water from the dishwasher! ­ The dishwasher can heat its own water to the temperature required by the wash program. This allows for connection of the machine to either a hot (max. [. . . ]