User manual PROEL PLLED125

[. . . ] This product should not be mixed with other commercial wastes for disposal. The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure, that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION - Before using this product read carefully the following safety instructions. Take a look of this manual entirely and preserve it for future reference. [. . . ] To use this as an alternate mix, switch in ALT 3-4 and all you have to do is connect the ALT 3-4 outputs to whatever destination you desire. When doing live sound or mixdown, it's often handy to control the level of several channels with one knob. Simply assign these channels to the ALT 3-4 mix, engage ALT 3-4 switch (44) in the CONTROL ROOM/PHONES section, and the signals will appear at the CONTROL ROOM and PHONES outputs. This setting is better if you intend to use the AUX 1 send as stage monitor, to have your stage mix independent from MAIN MIX. This signal is post-fader or in other words it depends by the position of the FADER LEVEL control. It adjusts the amount of channel signal sent to the left versus the right outputs if the channel is used as MONO, or it fades the LEFT or RIGHT signal amount if the channel is used as STEREO. This LED has two function: If the PEAK LED lights permanently this means that you have activated the SOLO switch of this channel. If the PEAK LED flashes this means that the input signal is near to the CLIPPING point. IMPORTANT: if the LED PEAK flashes reduce the level of the input signal using the GAIN control. This switch allows you to hear signals through your headphones or control room outputs. The dual-purpose MUTE/ALT 3-4 switch serves two functions: muting, and signal routing where it acts as an extra stereo bus. The VARIATIONS vary from from long delay times to short delay times. FLANGER - Typical modulation effect, creates a strong sweeping effect, particularly effective on rock electric guitar, lead and rhythm. The VARIATIONS vary from long tail to short tail. The VARIATIONS vary from long tail to short tail. When "TAP DELAY" effect is selected, by pushing at least two times this button, it's possible to set the desired delay time, according to music rhythm. This LED is activated only when Tap-Delay effect is recalled and flashes in sync with the delay time set by pushing the TAP button. 3mm) unbalanced (TS) jack for temporary, normally open footswitch (not supplied), suggested footswitches are PROEL model PFS20, PFS24, PFS29. When "TAP DELAY" effect is selected, pressing at least two times the footswitch it's possible to set the desired delay time, according to music rhythm. Engage this switch if you want to mute the signal coming from the internal effect. NOTE: the effect can be turned on/off also using a footswitch connected to the FX MUTE jack socket. This LED shows 2 conditions: · Flashing = signals a too high input level, near to the overload of the effect input stage. [. . . ] Set each recording channel's GAIN (3)(18) knobs and LEVEL (15)(29) fader so that you're getting good level without lighting the PEAK indicator on the mixer. The MAIN MIX (58) fader now acts like a master volume knob for all your mic/line inputs. Adjust this knob until you're getting good levels into your PC recording DAW software. ROOM/PHONES (46) knob now controls the level of your headphones (or studio monitors), but does not affect recording levels in your PC. [. . . ]