User manual PROEL PLLED145

[. . . ] This product should not be mixed with other commercial wastes for disposal. The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure, that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION - Before using this product read carefully the following safety instructions. Take a look of this manual entirely and preserve it for future reference. [. . . ] Set the MAIN MIX FADER at between "0" or a little bit down to "-5dB" to leave more dynamic at the amplifier input. While putting in some signal set the GAIN control so that the leds on the meter stay around "0" and never go higher than "+6dB", never the PEAK led of the channel must light on also. If you'd like to apply some EQ do so now and return to step 3. Repeat these operation for each channel. While playing all toghether set the MAIN MIX level to a confortable listening level, then adjust each channel FADER to obtain your own mix. For optimum sonic performance the channel and main mix FADERS should be set usually near the "0" marking. â· Always turn down MAIN MIX fader and C. When you shut down your equipment, turn off the amplifier first. â· When powering up, turn on the amplifier last. â· Never listen to loud music for prolonged periods. The M6 mono channels are designed to obtain the highest dynamic headroom and low noise possible in a wide range of adjustable gain of 70dB. If the signals are plugged into the XLR input there is a 0dB with the knob turned all way down, ramping up to 50dB of gain fully up. When connected to the jack input, there is 20dB of attenuation all way down and 30dB of gain fully up, with a unity gain (0dB) if positioned at 10 o'clock. This control gives you up to 15dB boost or cut at 12KHz with a "SHELVING" curve shape. Use it to add or reduce the sound "clarity" or "brightness". This control gives you up to 15dB boost or cut at 2. 5KHz with a "PEAKING" curve shape. Use it to add or reduce the sound "presence". This control gives you up to 15dB boost or cut at 80Hz with a "SHELVING" curve shape. Use it to add or reduce the sound "punch". This control sends the signal to the AUX output and to the internal DIGITAL EFFECT PROCESSOR, this signal is post-fader or in other words it depends by the position of the FADER LEVEL control. It adjusts the amount of channel signal sent to the left versus the right outputs if the channel is used as MONO, or it fades the LEFT or RIGHT signal amount if the channel is used as STEREO. [. . . ] As with nearly all power supply units, this one tends to get warm when left on for a while. Switch this one on and your mixer has power. Make sure that all master output knobs are turned all the way down when powering your mixer up or down. This switch activates and deactivates the phantom power on MIC Inputs. [. . . ]