User manual PROEL PLLED150

[. . . ] This product should not be mixed with other commercial wastes for disposal. The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure, that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION - Before using this product read carefully the following safety instructions. Take a look of this manual entirely and preserve it for future reference. [. . . ] Works well with vocals, guitars, woodwinds. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one. LARGE ROOM - This type of reverb reproduces the more intimate ambience of natural room acoustics. Features very fast and scattered early reflections, long pre delay. Works well with vocals, woodwinds, strings. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one. SMALL ROOM - This type of reverb reproduces the more intimate ambience of natural room acoustics. Feature very fast and scattered early reflections, short pre delay. Works well with vocals, fingered guitars, drums. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one, alternating hall, tape, spring or plate types of reverb. This LED has two function: If the PEAK LED lights permanently this means that you have activated the SOLO switch of FX1. If the PEAK LED flashes this means that FX1 send signal is near to the CLIPPING point of the internal FX1 DIGITAL EFFECT PROCESSOR. IMPORTANT: if the LED PEAK flashes reduce the level of the input signal using the AUX SEND 3 control. If you use AUX3 or AUX4 sends with external units (stage monitors or effects) the real clipping point is about +20dBu like the other AUX1 and AUX2 outputs: in these cases please don't consider the LED flashing, only refer to the level displayed on the external unit. IMPORTANT: if the LED PEAK flashes reduce the level of the input signal using the AUX SEND 4 control. Typically, it is set to MIX if the internal effect is used only for channels assigned to MIX bus or to one group if the internal effect is used only for channels assigned to the same group bus. Engage this switch if you want to mute the signal coming from the FX1 internal effect. You can connect a footswitch to MUTE both the FX1 and FX2 internal effects, suggested footswitches are PROEL model PFS20, PFS24, PFS29. NOTE: the FX1 and FX2 mutes change status each time the footswitch is pressed, in other words if both effects are ON they became both AFF, if one effect is ON and the other is OFF, they became OFF and ON respectively. This BNC connector provides +12V power supply for gooseneck lamps. Use only lamps with MAX 5W power consumption. [. . . ] Assign each channel both to MIX (17)(38) and 1-2 (18)(39) buses. The MAIN MIX (108) fader now acts like a master recording level control for all your mic/line inputs. Adjust this knob until you're getting good levels into your PC recording DAW software. The GROUP 1-2 (104) fader now acts like a monitoring level control for all your mic/line inputs, but it does not affect recording levels in your PC. [. . . ]