User manual PROEL PLLED155

[. . . ] This product should not be mixed with other commercial wastes for disposal. The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure, that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION - Before using this product read carefully the following safety instructions. Take a look of this manual entirely and preserve it for future reference. [. . . ] This LED has two function: If the PEAK LED lights permanently this means that you have activated the SOLO switch of this channel. If the PEAK LED flashes this means that the input signal is near to the CLIPPING point. IMPORTANT: if the LED PEAK flashes reduce the level of the input signal using the GAIN control. This switch allows you to hear signals through your headphones or control room outputs. Rotate this detented switch to select the preset effect you want to use. Dense, smooth reverb with simula l'ambiente di una grande sala da long tail, long pre delay and some early concerto. denso e armonioso riverbero con reflections. Works well with vocals, electric and acoustic guitars, strings. una coda lunga , lungo pre delay e poche prime riflessioni. Adatto a voci, The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from chitarre elettriche e acustiche, archi. Works well with vocals, guitars, woodwinds. TAP LED (segnalazione tempo di ritardo) least two times the footswitch it's possible to set the desired delay time, Questo LED è attivato solo quando l'effetto "TAP DELAY" è selezionato e lampeggia in sincrono con il tempo di ritardo impostato premendo il according to music rhythm. Engage this switch if you want to mute the signal coming from the internal effect. NOTE: the effect can be turned on/off also using a footswitch connected to the FX MUTE jack socket. This LED shows 2 conditions: · Flashing = indicates a too high input level, near to the overload of the effect input stage. In this case, reduce the level of the AUX 3 / FX sends. You can connect a footswitch to MUTE the mixer internal effect, suggested footswitches are PROEL model PFS20, PFS24, PFS29. Use it to reduce the level of signal sent to the internal effect is the PEAK LED is flashing. This control ranges from off through unity (the center detent position) on up to 15 dB of extra gain (fully clockwise). Typically, it is set to MIX if the internal effect is used only for channels assigned to MIX bus or to 1-2 if the internal effect is used only for channels assigned to 1-2 bus. This BNC connector provides +12V power supply for gooseneck lamps. Use only lamps with MAX 5W power consumption. [. . . ] Assign each channel both to MIX (17)(37) and 1-2 (18)(38) buses. The MAIN MIX (83) fader now acts like a master recording level control for all your mic/line inputs. Adjust this knob until you're getting good levels into your PC recording DAW software. The GROUP 1-2 (80) fader now acts like a monitoring level control for all your mic/line inputs, but it does not affect recording levels in your PC. [. . . ]