User manual PROEL PLML250SE

[. . . ] The specifics related in this manual are subject to modifications without any advance notice Rev. Every person involved with the installation, operation and maintenance of this device have to: Be qualified Follow the instructions of this manual INTRODUCTION Thank you for having chosen a PLML250SE. You acquired a versatile, powerful and high quality product. Unpack your PLML250SE Eclipse Wash Moving Head and make sure that there are no damages caused by transportation. [. . . ] Tighten the metal lid and the top chassis of the head too pay attention to fit together the bottom one. Do not operate this device with opened cover. Due to differences between lamps, fine adjustment may improve light performance. Open the shutter, set the dimmer intensity onto 100% and direct the light on a flat surface (wall for example). Center the hot-spot (the brightest part of the beam) using the two adjustment screws "A" and "B". Turn one screw at a time to drag the hot-spot diagonally across the projected image. If you cannot detect a hot-spot, adjust the lamp until the light is even. RIGGING DANGER TO LIFE: Please consider the respective national norms during the installation. The installation must only be carried out by an authorized dealer. The installation must always be secured with a secondary safety attachment, e. This secondary safety attachment must be constructed in a way that no part of the installation can fall down if the main attachment fails. When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges, under high working places and other endangered areas is forbidden. The operator has to make sure that safety-relating and machine-technical installations are approved by an expert before taking into operation for the first time and after changes before taking into operation another time. The operator has to make sure that safety-relating and machine-technical installations are approved by an expert after every four year in the course of an acceptance test. The operator has to make sure that safety-relating and machine-technical installations are approved by as killed person once a year. OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to) calculating working load limits, installation material being used, and periodic safety inspection of all installation material and the If you lack these qualifications, do not attempt the installation yourself, but instead use a professional structural rigger. improper installation can result in bodily injury and/or damage to property. The projector has to be installed out of the reach of people. If the projector shall be lowered from the ceiling or high joists, professional trussing systems have to be used. The projector must never be fixed swinging freely in the room. CAUTION: projectors may cause severe injuries when crashing down!If you have doubts concerning the safety of a possible installation, do NOT install the projector. [. . . ] ADDRESSING The Control Board on the front side of the PLML250SE allows you to assign the DMX fixture address, which is defined as the first channel from which the PLML250SE will respond to the controller. If you set, for example, the address to channel 5, the PLML250SE will use the channel 5 to 20 for control. Please, be sure that you don't have any overlapping channels in order to control each PLML250SE correctly and independently from any other fixture on the DMX data link. If two, three or more PLML250SE have the same address, they will work in similar mode. [. . . ]