User manual PROGRESS DIAMANT 812.6

[. . . ] The mains circuit for the socket used must be protected with a fuse with a rating of at least 10 A. Never remove the mains plug from the socket by pulling on the cable. Do not use the appliance if: - the cable is damaged. - the housing shows visible signs of damage. [. . . ] It locks in place and can be rotated all the way around. Press the release button and pull out the connector in order to remove the suction hose. Connecting the suction tubes Join the two tubes. Mains connection/Cable rewind The mains cable is in the cable compartment. Pull out the cable and insert the plug into the mains socket. Press the foot button; the cable rewinds automatically when vacuuming has been completed. Using the nozzles Adjust the Telescopic Tube (depending on model) Using the floor nozzle* For the daily care of carpets and hard floors. Without being changed over manually, the floor nozzle is entirely suited for daily vacuuming of carpets and hard floor surfaces such as parquet, tiles, linoleum, etc. 10 Using the floor nozzle* For the daily care of carpets and hard floors. The floor nozzle may be changed over manually. The brushes can be extended for smooth floors and retracted for carpets. Upholstery nozzle For vacuum cleaning all upholstered furniture, mattresses, etc. The thread lifting strips on the nozzle even pick up thread and lint. Switching on Switching on and off You can switch the appliance on and off by pressing the On/Off button. Power adjustment: Crevice and upholstery nozzle stored in the appliance For specific cleaning requirements, two additional parts are included with the vacuum cleaner in an integrated accessories compartment*. Open the compartment by pressing gently as shown in the figure. The nozzles may be attached to the suction tube or the handle on the suction hose, depending on requirements. Power adjustment - Rotary control* The suction power can be varied to suit individual vacuuming requirements using the electronic power adjuster. Crevice nozzle For vacuuming crevices, gaps and corners. *depending on model Power adjuster Secondary air regulator* Using the regulator on the handle, you can reduce the suction power, e. g. when vacuuming light items (net curtains, rugs). The wider you open the regulator, the lower the suction power at the nozzle becomes 11 Maintenance and cleaning Prior to maintenance or cleaning, ensure that the appliance is switched off and that the mains plug has been removed from the socket: Insert the new paper filter as far as it will go in the guide rails; only then can the lid be closed. The cover cannot be closed unless a paper filter has been inserted. Changing the microfilter We recommend replacing the microfilter at each fifth paper filter replacement, and at the latest when there is a clean dust bag and the dust level indicator is completely red with the nozzle raised. Changing the paper filter The paper filter must be replaced if the window on the filter replacement indicator is completely red when the appliance is operating at maximum power and the nozzle is raised from the floor. The paper filter should be replaced even if it does not appear to be full because fine dust can block the pores in the surface of the filter. Open the lid and fold up. Remove the used microfilter by means of the clean hygienic tabs (figure) and dispose of it with the household waste. [. . . ] the paper filter is damaged at some point and the motor protection filter becomes dirty Remove motor protection filter, clean (shake out) and replace. Insert new paper filter. What do I do, if . . . . . . it is difficult to push the nozzle Reduce the power setting on the appliance. [. . . ]