User manual PROGRESS P3840

[. . . ] ­ the housing shows visible signs of damage. · Avoid running over the mains lead with the appliance or the vacuum brush. · The cover cannot be closed unless a paper filter has been inserted. · Always ensure that a paper filter as well as a MICROFILTER and a HEPA filter are inserted. [. . . ] · Do not expose the appliance to the effects of the weather, humidity or sources of heat. · Should the mains lead be defective, the complete cable roller must be replaced by PROGRESS customer service or an authorised repair centre. · Repairs to electrical appliances may only be carried out by qualified specialists. Improperly effected repairs may result in significant risk to the user. · For this reason, if there is a malfunction in your appliance please contact your specialist dealer or PROGRESS customer service directly. 9 Preparing the vacuum cleaner for use The accessories can be connected by pushing and twisting, and can be disconnected by pulling them apart and twisting. Connecting the suction hose and suction tube. Join the suction hose handle firmly to the suction tube. Mains connection/Cable rewind The mains cable is in the cable compartment. Pull out the cable and insert the plug into the mains socket. Press the foot button; the cable rewinds automatically when vacuuming has been completed. Using the nozzles Connecting the suction tubes Join the two tubes. Using the floor nozzle* For the daily care of carpets and hard floors. Without being changed over manually, the floor nozzle is entirely suited for daily vacuuming of carpets and hard floor surfaces such as parquet, tiles, linoleum, etc. Attaching the suction hose Insert the suction hose connector in the suction inlet. It locks in place and can be rotated all the way around. Press the release button and pull out the connector in order to remove the suction hose. Using the floor nozzle* For the daily care of carpets and hard floors. This will not reduce cleaning efficiency. the motor thermal cut-out is activated If the motor is overloaded, e. g. due to a full filter bag or blocked accessory, the thermal cutout shuts down the motor. In this case, switch off the appliance, unplug from the mains, and leave the motor to cool down. Check paper filter bag, suction tube and suction hose; remove any blockage. The appliance can be switched on again after approximately 30 minutes. the fuse has blown The fuse may blow if you use other electrical appliances with high power consumption on the same electric circuit at the same time as the vacuum cleaner is in use. This can be avoided if you set the electronic power adjuster to the lowest power level and then select a higher level after switching the appliance on. Your vacuum cleaner can be fitted with a gentle start-up control which reduces the starting current to the motor and therefore prevents the electric circuit cut-out being triggered under normal conditions. It is possible that there will be a delay of about 4 seconds in the appliance starting up on the lowest power level. Paper filter Progress P58 Carrying and Storage To make the appliance easier to store and carry, slide the floor nozzle into the tool rail. Parking System For storing the suction pipe and nozzle during short pauses in vacuuming. The bracket on the nozzle is slid into the parking rail on the appliance. . . . [. . . ] Dies vorausgeschickt, leisten wir, AEG Hausgeräte GmbH, gegenüber dem Verbraucher Garantie für dieses Gerät für den Zeitraum von 24 Monaten ab Übergabe zu den folgenden Bedingungen: 1. Mit dieser Garantie haften wir dafür, dass dieses neu hergestellte Gerät im Zeitpunkt der Übergabe vom Händler an den Verbraucher die in unserer Produktbeschreibung für dieses Gerät aufgeführten Eigenschaften aufweist. Ein Mangel liegt nur dann vor, wenn der Wert oder die Gebrauchstauglichkeit dieses Geräts erheblich gemindert ist. Zeigt sich der Mangel nach Ablauf von sechs (6) Monaten ab dem Übergabezeitpunkt, so hat der Verbraucher nachzuweisen, dass das Gerät bereits im Übergabezeitpunkt mangelhaft war. [. . . ]