User manual PSE ARCHERY 2001 COMPOUND BOW

[. . . ] · When purchasing arrows for your bow, consult the selection chart from the arrow manufacturer and select the correct arrow for your application. Always use an arrow that meets the weight requirement marked on the specification label on the lower limb of your bow. Failure to do so could cause personal injury and damage to your bow. BOW MAINTENANCE Your PSE bow will give you many years of service if maintained and cared for properly. · Keep synthetic cables and string waxed. [. . . ] Sight: The sight should be installed according to the instructions received with the product. It is usually mounted to the riser in the threaded holes (holes "B") on the side opposite the shelf using the hardware provided with the sight. Stabilizer: Likewise, the stabilizer should be mounted according to the manufacturer's recommendation. It is usually mounted in the threaded hole on the front of the riser (hole "C"). Hole C Hole B Hole A Bow Sling: The bow sling attaches to the riser of the bow generally with the stabilizer. If a stabilizer is not used, attach the sling to the riser with the correct sized bolt using the hole provided for the stabilizer (hole "C"). OTHER ADJUSTMENTS Draw Weight: Your bow is factory-set to the peak draw weight indicated on the label on the lower limb of the bow. Slight changes in draw weight can be obtained by turning the limb bolt in or out. Before making any changes in weight turn the limb bolt clockwise until it no longer moves. Never use extreme torque when turning the bolt or damage to the limb may occur. The limb bolt then may be turned counterclockwise to obtain the desired weight, but NEVER more than 4 turns or revolutions. Wheels/Cams: Many PSE wheels and cams have adjustable features. Each one comes from the factory set-up and ready to use but there may be occasions where you need to adjust the characteristics of your bow. In some cases you will need a Tune Chart to determine what to adjust, and you may need to see a PSE Dealer for information. If you are not sure of the adjustment you are making, stop and see your PSE Dealer for assistance. In all cases, an appropriate bow press will be needed to make adjustments to cams and wheels. If you do not have an appropriate press, see your PSE Dealer. Your Authorized PSE Dealer is supplied with technical information on PSE bows and cams. Please see your Dealer for assistance when making these adjustments. CAM ADJUSTMENTS Ultimate One-Cam: Draw Length: To change the draw length in 1" increments the module must be changed. See your PSE Dealer for information on how to obtain a replacement module. For minor changes of draw length, the bow must be placed in a suitable bow press and with the tension relieved from the string/cable, move the string to appropriate peg to lengthen or shorten the effective length of the string. A shorter string makes shorter draw length and a longer string makes a longer draw length by 1/4". Draw Stop: The stop is an integral part of the module - no adjustment is necessary. Let-off: Let-off adjustment is part pf the design of the module. [. . . ] Moving the string to the peg that will lengthen the effective length of the string will lengthen the draw of the bow. Draw Stop: The position of the draw stop must match the size of the module. If the bow is equipped with a size 7 module, the draw stop must be attached to the cam using the number 7 holes provided. One-Cam: Draw Length: The bow must be placed in a suitable bow press and with the tension relieved from the string/cable, moving the string to the peg that will shorten the effective length of the string will shorten the draw length by 1/2". [. . . ]