User manual PULSAR V657

[. . . ] 2 Turn Crown clockwise while pressing it lightly until tight. 3 ADJUSTING CHRONOGRAPH HAND POSITION q Before setting the time, be sure to check that the CHRONOGRAPH hands are in "0" position when the chronograph is reset. (For resetting the chronograph, see "CHRONOGRAPH" on page 6) * If any of the CHRONOGRAPH hands do not return to "0" position, follow the procedure below to reset the hands. English CROWN Pull out to second click. Press repeatedly to reset CHRONOGRAPH 1/10second hand to "0" position. Press repeatedly to reset CHRONOGRAPH second and minute hands to "0" position. [. . . ] Otherwise, the date may not change properly. q When setting the hour hand, be sure to check that AM/PM is correctly set. The watch is so designed that the date changes once in 24 hours. * Turn the hands past the 12 o'clock marker to determine whether the watch is set for the A. M. If the date changes, the time is set for the A. M. q When setting the minute hand, first advance it 4 to 5 minute ahead of the desired time and then turn it back to the exact minute. 9 q While the crown is at the second click, do not press the buttons. Otherwise, the CHRONOGRAPH hands will move. To reset them to "0" position, see "ADJUSTING CHRONOGRAPH HAND POSITION" on page 4. CHRONOGRAPH q While the chronograph is counting, do not pull out the crown to set the time. Otherwise, the chronograph operation cannot be made. q The CHRONOGRAPH 1/10-second scale and hand differ in design and shape depending on the models. * Some models have the CHRONOGRAPH 1/10-second scale graduated on the upper half of the small dial and the hand which is so designed that both ends can indicate the elapsed 1/10 second. In that case, read the marker on the scale where either end of the hand points to. 10 English BATTERY CHANGE 2 Years Battery life : Approx. 2 years Battery : SEIKO SR920SW q If the chronograph is used for more than 60 minutes a day, the battery life may be less than the specified period. q As the battery is inserted at the factory to check the function and performance of the watch, its actual life once in your possession may be less than the specified period. q When the battery expires, be sure to replace it as soon as possible to prevent any malfunction. q We recommend that you contact an AUTHORIZED PULSAR DEALER for battery replacement. English 11 q Necessary procedure after battery change After the battery is replaced with a new one, or in case any of the hands should move improperly, follow the procedure below to reset the hands to "0" position. A English B * The CHRONOGRAPH second hand turns half a circle counterclockwise and then returns where it was. The CHRONOGRAPH 1/10-second hand turns a full circle clockwise and stops. ** The hands move quickly if the respective buttons are kept pressed. and CROWN CROWN 12 v v v v A CROWN Pull out to second click. B Press and hold at the same time for 2 seconds. * Press repeatedly to reset CHRONOGRAPH 1/10second hand to "0" position. ** Press repeatedly to reset CHRONOGRAPH second and minute hands to "0" position. ** Turn to set the time. Push back in to normal position. A B v WARNING q Do not remove the battery from the watch. q If it is necessary to take out the battery, keep it out of the reach of children. [. . . ] However, the above conditions will be corrected when the watch returns to normal temperature. MAGNETISM Your watch will be adversely affected by strong magnetism. Keep it away from close contact with magnetic objects. English N S CARE OF CASE AND BRACELET To prevent possible rusting of the case and bracelet caused by dust, moisture and perspiration, wipe them periodically with a soft dry cloth. 15 SHOCKS & VIBRATION PERIODIC CHECK English Light activities will not It is recommended that the affect your watch, but be watch be checked once 2-3 careful not to drop your every 2 to 3 years. Have Years watch or hit it against hard your watch checked by an surfaces, as this may AUTHORIZED PULSAR cause damage. DEALER or SERVICE CENTER to ensure that the case, crown, buttons, gasket and crystal seal remain intact. [. . . ]