User manual PULSAR Y182

[. . . ] 2 Turn Crown clockwise while pressing it lightly until tight. 3 DATE SETTING Date CROWN 1 1 Pull out to first click. « 5 2 English CROWN 1 3 « 6 4 4 v v v 2 Turn clockwise until the date for the previous day appears. 3 Pull out to second click and turn until the desired date appears. 4 Push back in to normal position. 1 « TIME SETTING CROWN 1 Hour hand Minute hand 1 Pull out to second click when Second hand is at the 12 o'clock position. « 2 3 CROWN 1 Second hand v 2 Turn to set Hour and Minute hands. 1 English v 3 Push back in to normal position in accordance with a time signal. « 5 ALARM Alarm time is set on a 12-hour basis and indicated by ALARM hour and minute hands that move independently of MAIN TIME hands. ALARM SETTING 1 Adjustment of ALARM hands English After the main time is adjusted, follow the procedure below, and then set the alarm. * The following procedure is necessary only after the main time is adjusted. Hour hand (MAIN TIME) Minute hand (MAIN TIME) CROWN 2 1 Pull out to second click. « 3 6 ALARM hands 1 2 v 2 Turn to set ALARM hands to the current time (MAIN TIME). CROWN 2 v 3 Push back in to normal position. « 2 Alarm time setting * Once ALARM hands are adjusted to the main time, alarm time setting can be made only by following the procedure below. CROWN 2 CROWN 2 Pull out to first click. Press repeatedly to set ALARM hands to the desired alarm time. [. . . ] q It is necessary to adjust the date at the end of February and 30-day months. English 14 TIME SETTING q When setting Hour hand, check that AM/PM is correctly set. * The watch is so designed that the date changes once in 24 hours. Turn the hands past the 12 o'clock marker to determine whether the watch is set for the A. M. If the date changes, the time is set for the A. M. If the date does not change, the time is set for the P. M. q When setting Minute hand, advance it 4 to 5 minutes ahead of the desired time and then turn it back to the exact minute. ALARM q When setting ALARM minute hand, advance it 4 to 5 minutes ahead of the desired time and then turn it back to the exact minute. q Alarm hands move quickly if Button C is kept pressed. q If CROWN 2 is pulled out to first click within 1 minute after being pushed back in to normal position, the alarm sounds. q If CROWN 2 is pulled out to second click, the designated alarm time is canceled with a warning beep. * In that case, set ALARM hands to MAIN TIME again, push CROWN 2 back in to normal position, and then, pull it out to first click and set the desired alarm time again. However, if CROWN 2 is pushed back in to normal position before the warning beep stops, the designated alarm time will not be canceled. STOPWATCH q If CROWN 1 is pulled out to second click, STOPWATCH hands are reset to "0" position. q If CROWN 2 is pulled out to first or second click, STOPWATCH hands are reset to "0" position. q When stopwatch has been reset and Button A is pressed before the hands reach "0" position, stopwatch still starts counting when Button A is pressed. English ADJUSTING THE HAND POSITION q Hands move quickly if the respective buttons are kept pressed. q After adjusting the hand position, set the main time. RESETTING THE BUILT-IN IC q Before using the watch again, be sure to set the main time, adjust the position of STOPWATCH hands and set the alarm. 15 BATTERY CHANGE 2 Years Battery life : Approx. 2 years Battery : SEIKO SR927W q As the battery is inserted at the factory to check the function and performance of the watch, its actual life once in your possession may be less than the specified period. q When the battery expires, be sure to replace it as soon as possible to prevent any malfunction. q We recommend that you contact an AUTHORIZED PULSAR DEALER for battery replacement. English 16 q Battery life indicator When the battery nears its end, the small second hand moves at two-second intervals instead of normal one-second intervals to indicate that the battery needs to be replaced with a new one. * If the alarm is used while Second hand is moving at two-second intervals, the watch may stop operating. Replace the battery as soon as possible. WARNING q Do not remove the battery from the watch. q If it is necessary to take out the battery, keep it out of the reach of children. If a child swallows it, consult a doctor immediately. q Never short-circuit, tamper with or heat the battery, and never expose it to fire. [. . . ] However, the above conditions will be corrected when the watch returns to normal temperature. MAGNETISM Your watch will be adversely affected by strong magnetism. Keep it away from close contact with magnetic objects. English N S CARE OF CASE AND BRACELET To prevent possible rusting of the case and bracelet caused by dust, moisture and perspiration, wipe them periodically with a soft dry cloth. 19 SHOCKS & VIBRATION PERIODIC CHECK English Light activities will not It is recommended that the affect your watch, but be watch be checked once 2-3 careful not to drop your every 2 to 3 years. Have Years watch or hit it against hard your watch checked by an surfaces, as this may AUTHORIZED PULSAR cause damage. DEALER or SERVICE CENTER to ensure that the case, crowns, buttons, gasket and crystal seal remain intact. [. . . ]