User manual PULSAR Y735

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual PULSAR Y735. We hope that this PULSAR Y735 user guide will be useful to you.

Lastmanuals help download the user guide PULSAR Y735.


Mode d'emploi PULSAR Y735
Download
Manual abstract: user guide PULSAR Y735

Detailed instructions for use are in the User's Guide.

[. . . ] q When the illuminating light becomes dim, replace the battery with a new one. If the light remains dim after replacing the battery, have the electroluminescent panel replaced with a new one by the retailer from whom the watch was purchased. The replacement will be made at cost. D D Press and hold to show the designated alarm time. ENGAGEMENT/DISENGAGEMENT OF ALARM AND HOURLY TIME SIGNAL With each press of C while keeping D pressed, the alarm and hourly time signal are engaged and disengaged in the following order: Alarm mark Alarm and hourly time signal disengaged Alarm disengaged and hourly time signal engaged Alarm and hourly time signal engaged Alarm engaged and hourly time signal disengaged C D Hourly time signal mark ALARM SETTING MODE A Press for 2 seconds in TIME/CALENDAR or STOPWATCH mode to show ALARM SETTING mode. STOPWATCH MODE q The stopwatch measures up to 24 hours in 1/100 second increments for the first 40 minutes and in 1 second increments thereafter. [. . . ] In doing so, the display as shown below will appear. The display will return to the TIME/CALENDAR as the buttons are released. TIME/CALENDAR SETTING MODE A Press to show TIME/CALENDAR SETTING mode. TIME/CALENDAR SETTING indicator C A D V Selection of the digits Seconds ¿ Minutes ¿ Hour ¿ Month ¿ Date ¿ Day ¿ q When setting the seconds, press button D in accordance with a time signal. The seconds are reset to "00" and start immediately. q In second setting, when the seconds count any number from "30" to "59" and button D is pressed, one minute is added and the seconds are reset to "00". q The flashing digits move quickly if button D is kept pressed. q When setting the hour digits in the 12-hour indication, be sure to check that AM/ PM is correctly set. v A v v C Start 5 bar WR Split / Split release 10/15/20 bar WR v D C v D D Reset Finish time of 1st competitor 2nd competitor finishes Finish time of 2nd competitor q q q q q Restart and stop of the stopwatch can be repeated by pressing button C. Measurement and release of split time can be repeated by pressing button D. When button C or D is pressed, a beep sounds to confirm the stopwatch operation. The 1/100 second indicator flashes during the first 40 minutes of measurement. While the stopwatch is stopped, the stop indicator flashes. While the split time is measured and displayed, the split indicator flashes. q Even if the STOPWATCH mode is changed to another while the measurement is in progress, it continues counting properly. q When measuring a long period of time, return the STOPWATCH to the TIME/ CALENDAR mode after the stopwatch starts, to prevent any possible mistaken operation. * Pressure in bar is a test pressure and should not be considered as corresponding to actual diving depth since swimming movement tends to increase the pressure at a given depth. Care should also be taken on diving into water. ** We recommend that you wear a PULSAR Diver's Watch for scuba diving. TEMPERATURES +50°C -5°C Your watch works with stable accuracy within a temperature range of 5° C and 35° C (41° F and 95° F). Temperatures over 50° C (122° F) or below ­5° C (+23° F) may cause a slight time loss or gain or battery leakage or shorten the battery life. However, the above conditions will be corrected when the watch returns to normal temperature. CHEMICALS MAGNETISM The watch will not be affected by magnetism. N S BATTERY CHANGE 5 Years Battery life : Approx. 5 years Battery : SEIKO CR2016 Be careful not to expose the watch to solvents, mercury, cosmetic spray, detergents, adhesives or paints. [. . . ] The battery may burst, become very hot or catch fire. CARE OF CASE AND BRACELET To prevent possible rusting of the case and bracelet caused by dust, moisture and perspiration, wipe them periodically with a soft dry cloth. LIQUID CRYSTAL PANEL The normal life expectancy for the liquid crystal panel of the watch is approxi5 Years mately 5 years. After that it may decrease in contrast, becoming difficult to read. Please contact your AUTHORIZED PULSAR DEALER or SERVICE CENTER if you wish to have a new panel fitted (guaranteed one year). STATIC ELECTRICITY CAUTION q The battery is not rechargeable. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE PULSAR Y735

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual PULSAR Y735 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag