User manual PUR LINE HEATY 126

[. . . ] 0mm² or larger and rated not less than 1890 watts. Never use a single extension cord to operate more than one heater. Do not operate heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. return heater to authorized service facility for examination , electrical or mechanical adjustment or repair. [. . . ] It must not be used in potentially dangerous locations such as flammable, explosive, chemical-laden or wet atmosphere. This heater is not intended for use in wet or damp locations. Never locate a heater where it may fall into a bathtub or other water container 14. Carefully remove the heater from the carton and the bag. Make sure that the heater is in the "OFF" position before plugging the heater into an Outlet. When the heater is initially plugged in and turns on the power switch on the rear of the unit, there will be a « beep » and the power indicator will be on indicating that there is power to the unit. The indicator will remain lit until the power switch on the rear of the unit is turned off. Upon turning the heater on, the unit will be in the LOW heat mode (1100 watts), the « LO » and current room temperature will be displayed on LED circularly during 5 seconds. Pressing the " Power & Mode " button at this point will set the heater into the HIGH heat mode (1800 watts), the « HI » and current room temperature will be displayed on LED circularly during 5 seconds. Pressing the "Power & Mode" button at this point will set the heater into the AUTO mode (1800 watts). the LED will display the default temperature of 25° flickeringly. Notice that now C If you do not set the temperature in 3 seconds, the LED will stop blinking and will display the "AU" and current room temperature circularly during 5 seconds. Pressing the "Power & Mode" button once more will set the heater into the FAN mode (15 watts). The "FA" and current room temperature will be displayed on LED circularly during 5 seconds. Fan mode is only for fan operation, without any heat output. Pressing the "Power & Mode "button again and the heater will go back to LOW heat mode. continuing to press the button will cycle the unit through LOW , HIGH , AUTO , FAN mode. To cut off the unit, press the "Power & Mode" button and hold 2 seconds. Do the same to turn the heater off, then turn off the power switch and remove plug from power outlet. Press the "Power &Mode "button until the heater is set into the AUTO mode. [. . . ] WARRANTY: The warranty is valid for 2 years for a « manufacturing fault ». OSCILLATION FUNCTION : This function will work in any mode. Pressing the oscillation button (OSC) will allow the heater to oscillate back and forth. This heater includes an audible alarm to warn that parts of the heater are getting excessively hot. [. . . ]