User manual PUR LINE MOBY 100

[. . . ] Use only the hose provided and clip exhaust hose and unit adaptor to the back of the air conditioner Avoid kinks and bends in the exhaust hose as this will cause expelled moist air to build up causing the unit to overheat and shut down. Fig 8 & 9 show correct position The hose may be extended from 300mm to 1500mm but for maximum efficiency use the shortest length possible. The length of the exhaust pipe is specially designed according to the specification of this product. Do not replace or prolong it with your own private hose as this could cause the unit to mal-function. [. . . ] In cooling mode, by pressing the SLEEP button, the set temperature will increase 1oC at the 1st hour, another 1 oC at the second hour, then keeps at that temperature. In heat mode, by pressing the SLEEP button, the set temperature will descend 1oC at the 1st hour, another 1 oC at the second hour, then keeps at that temperature. In sleep mode, the ventilation will keep at low speed. Re-press the SLEEP button, the setting temperature and ventilation speed will return to the pre-selected one. The unit will shut down automatically after the SLEEP function running for 12 hours. Please note, the sleep function is not available while the machine is working in ventilation, dehumidification or auto mode. When the machine is in Sleep function, the Fan Speed would turn to be LOW speed. Swing function By pressing SWING button, the air vent will rise in 3 different angles: 45º 60º 75º Every time when you turn on the machine, the air vent will rise to position 75º first, then return to position 45º automatically. For resetting the angle, the air vent will rise to 75º first, too. As you turn off the air vent, the air vent will close. All the above functions can also be performed with the supplied remote control. To prolong the compressor's life, after switch-off of the unit, please wait for 3 minutes (at least) before re-switch. The cooling system will switch off if the ambient temperature is lower than the set one. The ventilation, however, keeps working on the set level. If the ambient temperature rises above the selected level, the cooling will return to work. Dehumidification function In dehumidification mode, the temperature cannot be adjusted, the ventilation will fix at low speed. This is only for the model with TiO2 or Ionizer function, i. These 2 functions can clean the air, improve the air quality. self-diagnosis This machine is equipped with self-diagnosis function. If something is wrong in the machine, the LCD will show the word "E1" or "E2". As this time, please call your service centre. During the process of cooling, some water will be extracted from the air into the unit. [. . . ] Cleaning the filter Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt from the filters and then rinse thoroughly under running water (no hotter than 40oC). Never operate the unit without the filters. is the comp / `full water' indicator flashing?Is the room temperature below the set temperature? [. . . ]