User manual PVG STOVER R 222 C

[. . . ] R 22x C 3 2 6 5 4 > 1 MANUEL D'UTILISATION GEBRAUCHSANWEISUNG BRUGSANVISNING INSTRUCCIONES DE USO OPERATING MANUAL ISTRUZIONI D'USO GEBRUIKSAANWIJZING 2 14 26 38 50 62 74 Dear Sir, Madam, Congratulations on your purchase of this heater. You have purchased a quality product, which will serve you for many years to come. This, of course, provided you use the heater correctly. Please read these Directions for Use first, to ensure the maximum lifetime for your heater. [. . . ] The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. The flame can be slightly adjusted with the knurled wick adjustment knob (Fig. Burning that is too low may be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (put window or door ajar) (contact your dealer or replace the wick, refer to section L) When there is insufficient ventilation in the room, the heater shuts off automatically. After improving the ventilation of the room (e. g. by opening a door or window a little more), the heater can be ignited again. This heater is equipped with a safety mechanism which switches off the heater when N E F G the removable fuel tank is taken out of its compartment. To re-ignite the heater, place the removable fuel tank back in the heater and follow the instructions as described in chapter C. SWITCHING OFF THE HEATER Push the OFF-button . The flame will extinguish after a little while (Fig. N). MALFUNCTION, CAUSES AND SOLUTIONS If any malfunctioning cannot be solved from the directions below, please contact your dealer. THE HEATER DOES NOT IGNITE The batteries are not positioned correctly in the holder. There is not enough power left in the batteries for the ignition. You have run out of fuel from the tank or the wick has been replaced. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. You are pushing the ignition button with too much force. Contact your dealer. 4 55 IRREGULAR FLAME AND/OR SOOT AND/OR SMELLS The combustion chamber has not been positioned correctly. Use the handle to put it level, until you can easily slide it slightly to the left and to the right and the chamber is level. You are using fuel which is past its `use by' date. Start every heating season with fresh fuel. You are using the incorrect type of fuel. Refer to THE RIGHT FUEL (See Section 'What you need to know in advance'). Dust has gathered in the lower part of the heater. THE HEATER SLOWLY EXTINGUISHES The removable tank is empty. [. . . ] 13 Install the wick sleeve (with wick) to the primary air tube. And then install the top of the stem into the groove of the wick sleeve (with wick) from right side, and left the stem to the end. Then tighten the screw which is holding the stem. 15 Put the wick holder chassis back into position. 13a 13b 14a 100 cm 14b 20 cm 16 Screw the four wing nuts hand tight. [. . . ]