User manual PYLE PDWM100

[. . . ] Avoid using the system where it may be subjected to heat, such as in direct sunlight, near radiators or other heat sources. Should any liquid be spilt on the system, stop using it immediately. It may be possible to dry the system, but you should have it checked by a qualified technician before using it again. [. . . ] It may be possible to dry the system, but you should have it checked by a qualified technician before using it again. Take care with the mains power adapter and lead. If damaged in any way, do not use the system, and refer to a qualified technician for repair. Only use the system with the supplied components, do not attempt to use with any other mains power supply adapter . If the microphone is not going to be used for a time, remove the battery to prevent leakage. In the event of electrolyte leakage inside the battery compartment, carefully remove using a damp cloth. Take care not to get battery electrolyte in contact with your skin, however, if it does, wash your hands under a running tap. If electrolyte comes into contact with your eyes, seek medical advice immediately. With voltage selector switch for selecting a suitable AMPLIFIER one according to different countries. VOLTAGE SELECTOR SWITCH BATTERY CONDITION INDICATOR POWER SWITCH BATTERY COVER MAINS POWER ADAPTER RADIO MIC RECEIVER UNIT ANT MIX SQUELCH DC 12V ANT SPEAKERS BALANCED AF. OUT BALANCED MICROPHONE BATTERY. Unscrew the battery cover at the end of the microphone, Install the provided 9 volt battery, taking care to fit it with the correct polarity connected, Check the battery by switching the microphone ON, The red LED will come on for one second and then go OFF, this indicates correct operation, If the red LED stays ON or is dim, this indicates the battery is low and should be changed, If the red LED does not come on at all, it indicates the battery is dead, please change it right now, MICROPHONE ---3--- ---4--- TROUBLE SHOOTING Please read and check the following points before asking for service. The wireless microphone fails to work: check the microphone battery by switching the microphone ON, the red LED battery condition indicator should come on for a second and then go off. If the red LED stays on or is dim, replace the battery. If the red LED fails to come on, check the battery polarity or change battery. Check the POWER indicator on the receiver unit is ON, if not, check the mains power adapter is firmly plugged into a working mains socket. Check the amplifier system is ON and the microphone controls set correctly. Check the wireless microphone jack lead is firmly connected into the output socket on the rear panel of the receiver unit, and into the MIC input socket on your amplifier. [. . . ] Check the POWER indicator on the receiver unit is ON, if not, check the mains power adapter is firmly plugged into a working mains socket. Check the amplifier system is ON and the microphone controls set correctly. Check the wireless microphone jack lead is firmly connected into the output socket on the rear panel of the receiver unit, and into the MIC input socket on your amplifier. [. . . ]