User manual PYLE PDWM96

[. . . ] Should any liquid be spilt on the system, stop using it immediately. It may be possible to dry the system, but you should have it checked by a qualified technician Precautions Products figure Hand-held microphone Bodypack transmitter Receiver Front panel Receiver Rear Panel Installation Trouble shooting Specifications before using it again. Take care with the main power adapter and lead. If damaged in any way, do not use the system and refer to a qualified technician for repair. [. . . ] Only use the system with the supplied components. Do not attempt to use with any other main power supply adapter . If the wireless system is not going to be used for a while, remove the battery to prevent leakage. In the event of electrolyte leakage inside the battery compartment, carefully remove the leakage with a damp cloth. Take care not to get battery electrolyte in contact with your skin, however if it does, wash your hands under a running tap. If electrolyte comes into contact with your eyes, seek medical advice immediately. Only replace the battery with the same or an equivalent type. Please dispose of old batteries in an environmentally friendly manner in accordance with the relevant legislation. Do not use any solvents to clean any part of the wireless system . A. Overall system Oscillation mode: Carrier Frequency Range: Stability: Max Deviation: Dynamic Range: S/N Ratio: T. H. D: Squelch: Frequency Response: Operating range: B. Receiver Sensitivity: Image Rejection: Stability: Audio output: Power supply: Dimensions(m/m): C. Connect the mains power adaptor from "DC 15V" jack to a suitable mains power socket. away from wall BELT CLIP BATTERY COVER AUDIO OUTPUT JACK VOLUME SWITCH AUDIO SWITCH POWER SWITCH LOW BAT ON MUTE -20dB 0dB OFF ON MIC/LINE AUDIO POWER ATTENUATION POWER MIC LINE MIC LINE MIC LINE MIC LINE MIC LINE 9V + ANTENNA HEADSET MIC LOW BATTERY LED POWER LED LAVALIER MIC DC IN 15V/500mA XLR MIXED MIXED CH-1 SQ4 SQ3 SQ2 SQ1 Open the battery cover to install a 9V battery (check polarities). Move the power switch to the ON position. The power indicator will be green to indicate normal operation. If the LOW BAT indicator turns red, replace with a fresh battery promptly. Before operation, please confirm that the frequency of transmitter is same as the frequency of receiver. Plug the 3. 5mm connector of headset mic to screw-lock socket of transmitter. The MUTE switch cuts off the audio output without shutting off the transmitter. Move it to 0dB position to get normal volume output. Move it to -20dB position to reduce distortion and avoid feedback. [. . . ] Move it to 0dB position to get normal volume output. Move it to -20dB position to reduce distortion and avoid feedback. If the system will not be used for a long time, please switch off the transmitter to avoid power consumption. 7 FRONT PANEL 3 1 4 5 6 7 8 9 10 11 REAR PANEL 3 DC IN 15V/500mA PDWM96 VHF PROFESSIONAL FOUR CHANNELS WIRELESS MICROPHONE SYSTEM VOLUME RF AF LEVEL VOLUME RF AF LEVEL VOLUME RF AF LEVEL VOLUME RF AF LEVEL XLR MIXED MIXED CH-1 SQ4 SQ3 SQ2 SQ1 CHANNEL 1 CHANNEL 2 CHANNEL 3 CHANNEL 4 17 16 18 19 POWER 20 21 16 2 12 13 7. CH-2 RF Signal Indicator 17. Balanced output jack 18. Unbalanced output jack 19. CH-1 Output jack 20. Squelch adjustor 21. DC Power in Attach the two antennas and extend them vertically. [. . . ]