User manual PYLE PL2DNTV7

[. . . ] 2-DIN TFT-LCD Monitor with TV/Radio tuner PL2DNTV7 Owner's manual Please read it before using this equipment. www. pyleaudio. com CONTENTS Welcome . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . General Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Operating Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Menu/Band (1) CDC mode Return to the DVD main menu during playing DVD media. 4 (2) Radio mode To switch the band in the follows order: FM1 > FM2 > FM3 > MW1 > MW2 press and hold this button to automatically search all stations and store the stations on band FM3 or MW2. Audio CH Select Tone: JAZZ-ROCK-CLASSIC-POP-VOCAL-FLAT-EQ OFF. VOL+ / To increase volume or reduce volume. PBC/LOC (1) CDC mode To select play mode: PBC on/PCB off. (2) Radio mode As PS function, to scan all pre-set station of the current band (M1~M6, step: 5seconds). Audio (1) CDC mode, To select audio language when playing DVD disc. (2) Radio mode To select stereo / mono 22. Title Under CDC mode, to display DVD title during playing DVD media. Sub-Title Under CDC mode, to select sub-title language during playing DVD media. Angle It's only available when playing DVD disc, which recorded some pictures from different angles. Press it to select from different filming angles stored on the DVD media during playback. Go to Under CDC mode, to select playtime and desired chapter. RPT Under DVD mode, allows the user to repeat playback: repeat mode: disc, track/chapter 28. USING REMOTE CONTROL Aim the IR remote control directly at the unit, or video source with an IR input. Tips: - Maximum IR distance is 3 meters from the sensor. - Direct sunlight or very bright light reduces sensitivity to the IR remote signal commands. Make sure the monitor is not located in direct sunlight. - Obstruction between the remote sensor and remote control may disrupt reception. BATTERY If the remote control does not function the operating range is shortened, please change to a new battery. Follow the arrow 1 slide it to the right toward the battery while at the same time pull the battery holder away from the remote control. Insert a new battery with the (+) side up. [. . . ] To prevent short circuits, remove the key from the ignition and disconnected the terminal of the battery. Connect the wiring harness cables in the following order: ground wire, battery wire, ignition wire. Connect the input and output cable correctly to each unit. Connect the wiring harness connector to the monitor unit. [. . . ]