User manual PYLE PLCAP800HB

[. . . ] radio, CDP, CDC, tape, TV or AUX mode) 6 Press EQUALIZER button (12) over 1 second, graphic display type will display on the LCD and then press TUNE/TRACK/SKIP button (16) or TUNE/TRACK/SKIP button (17) to select graphic display type as follows: DNCO1 DNCO2 DNCO3 DNCO4 DNCO5 · REMOTE SENSOR (OPTIONAL) Point the remote control handset to the remote sensor IR (25). Press the function keys on the handset to control the system. · AUXILIARY INPUT The unit can be connected to a portable audio player through the AUX IN jack (11). · RESET RESET button (30) must be activated with either a ball point pen or thin metal object. [. . . ] In local mode, "LOC" will display. · MONO/STEREO At FM radio mode, press MO/ST button (8) to set the reception between mono mode and stereo mode. In stereo mode, when stereo broadcasting station is received, the " " indicator will appear upon the display. · AUTOMATIC MEMORY STORING & PRESET SCAN - Automatic Memory Storing Press AS/PS button (14) over 1 second in radio mode, Auto Store is started. 7 OPERATION CASSETTE OPERATION · TAPE OPEN/CLOSE Press TAPE OPEN/CLOSE button (26), the front panel will slide down to show the cassette compartment (28). Press TAPE OPEN/CLOSE button (26) again or POWER button (9) to slide up the front panel. · PROGRAM BUTTON These two buttons (27) perform the dual functions of changing the direction of tape playback and fast forward/rewind of the tape. - Change Tape Playback Direction Press both buttons together to play the other side of a tape. - Fast Forward/Rewind Press the button with the double arrows pointing the same direction as the direction indicator in the LCD to fast forward; press other button in the opposite direction to fast rewind. · EJECT When the front panel slides down, push the eject button (29) down to eject the cassette tape. 8 OPERATION CDP OPERATION · CD OPEN/CLOSE/EJECT Press CD OPEN/CLOSE/EJECT button (4) shortly, the front panel will slide down halfway to show the disc slot (5). Press CD OPEN/CLOSE/EJECT button (4) again or POWER button (9) to slide up the front panel. When the front panel slides down, insert a disc into the disc slot (5), the front panel will automatically slide up. If there has a disc in, when the front panel slides down, press CD OPEN/CLOSE/ EJECT button (4) for over 1 second to stop CD playing and eject the disc from the disc slot. Remove the cassette tape in the player, then put in the new one. Cool off the inside of the car, then try again. Leave the cassette player off for an hour or so, then try again. Adjust the installation angle to less than 30 degrees. Clean the compact disc, then try to play a new one. Try another cassette. Cassette tape cannot be loaded or ejected. Presence of a cassette tape in the player. Condensation. No sound. Volume is in minimum. Wiring is not properly connected. Sound skips or sound quality is poor. The installation angle is more than 30 degrees. The disc is extremely dirty or defective disc. The cassette is defective. The operation keys do not work. The built-in microcomputer Press the RESET button. is not operating properly Front panel is not properly fixed into due to noise. [. . . ] Allow the tape head, capstans and pinch rollers to dry before operating. Do not touch the tape with your fingers; if it becomes lose, wind it back by twisting a six-sided pencil in the cassette reel. Clean the tape head with the cotton swab. For Tape Player Periodic cleaning of the tape head and capstan shaft will ensure good reproduction of music and trouble-free operation. Cleaning of the tape head should be done every 20 to 30 hours of operation or when the high tones have become less clear. [. . . ]