User manual PYLE PLCD82MP Instruction Manual

[. . . ] Slowly increase the sound until you can hear it comfortably and clearly, and without distortion we want you listening for a lifetime. Once you have established a comfortable sound level: . Taking a minute to do this now will help to prevent hearing damage or loss in the future. After all, we want you listening for a lifetime. [. . . ] . Do not expose the disc to direct sunlight or heat sources such as hot air ducts. Or leave it in a car parked in direct sunlight where there can be a considerable rise in temperature. 9 2 INSTALLATION INSTALLATION WAY IT IS AN ANTI-THEFT INSTALLATION WA THE CHASSIS WEAR A MET Y. PLEASE HAVE THE WIRING CONNECTION OF THE POWER SUPPLY SPEAKERS AND ANTENNA AS FOR THE REQUIREMENT , OF THE MANUAL, THEN INSTALL THE METAL SLIDING HOUSING INTO THE CAR ACCORDING TO THE DIAGRAM. TO BOOST UP THE CAPABILITY OF ANTI-JAMMING, PLEASE FIX THE METAL STRAP ON THE METAL CONNECTED TO THE BOTTOM BRACKET OF THE CAR. REMOTE CONTROL BASICS BATTERY REPLACEMENT: 1. Remove the battery holder as the direction indicated by the arrow. 2. Replace the battery Set a new battery property with (+)side up. Push in the holder to the original position. NOTE ON BATTERIES: Old batteries must immediately be removed and disposed. BATTERY INFORMATION: SELECT THE PROPER FIXER FOR FIXING THE SLIDING METAL HOUSING. METAL STRAP Designated Battery: UM-4"AAA"/R05 Battery Life: 6 months with normal use (in normal room temperatur) CAUTION: UNIT CHASSIS PLASTIC TRIM OUT DASH BOARD SLIDING METAL HOUSING Improper use of batteries may cause overheating, explosion or ignition. Resulting in jury or fire . Battery leakage may cause damage to the unit. Do not disassemble or short the batteries. Do not throw the batteries into the fire. To avoid the risk of accident, keep the batteries out of reach of children. FRONT PANEL TO DRAW THE CHASSIS OUT OF THE SLIDING METAL HOUSING, INSERT THE LEFT AND RIGHT KEY PLATES INTO THE RIGHT POSITION OF THE 2 SIDES OF CHASSIS. TO INSTALL THE FRONT PANEL BACK INTO THE UNIT CHASSIS, FIRSTLY INSTALL THE RIGHT SIDE IF IT BACK INTO THE RIGHT POSITION, THEN PUSH THE LEFT SIDE BACK TO THE UNIT CHASSIS TILL OK. NOTE REMOVE AWAY 2 SCREWS FOR PROTECT THE DECK BEFORE OPERA TING IT. REMOVE THE SLIDING METAL HOUSING AWA Y PRESS RESET BUTTON TO RESUME THE DISTORTED PROGRAM WHEN THE LCD DISPLAY IMPROPERLY AND SOME BUTTONS ARE INVALID. RESET BUTTON 1. LOCAL/DISTANCE BUTTON If you find the receiving signal is weak and there is the word LOC displayed on LCD when you tune for distance station, firstly press the button to disappear the word LOC on LCD, then tune again for the distance station. If you find the interference to the receiving signal is very strong and there is not the word LOC displayed on LCD when you tune for local station, firstly press the button to display the word LOC on LCD, then tune again for the local station. AFTER FLIPPING DOWN THE FRONT PANEL, DRAW THE FRONT PANEL OUT OF THE CLIP. 2. LOUDNESS BUTTON Press it to enhance the BASS sound effect immediately when it is in BASE mode. OPEN BUTTON TO INSERT DISC INTO COMPARTMENT OR EJECT DISC OUT OF THE COMPARTMENT OR TAKE THE FRONT PANEL AWAY THE UNIT CHASSIS, PRESS THE OPEN BUTTON TO FLIP DOWN THE FRONT PANEL. 3 8 LOCATION AND FUNCTION OF CONTROLS 12. PRESET STATION [ 1-6 ] AND TOP/CDP, INT, RPT, RDM BUTTONS. (A]. To memorize the current frequency, press any one of the six preset buttons hold for more than 2 seconds. (B]. To recall the preset memory, press one of the preset buttons [1-6]. (C). In CDP mode, press TOP/CDP button to pause CDP playback, press it again to resume CDP playback. Press it hold for more than about 0. 5 seconds to play the first track of the disc. (D). In CDP mode, press INT button to play the first 10 seconds part of each track, press it again to stop INT mode and retain playing the track currently selected. (E). In CDP mode, press RPT button to play the current track repeatedly. [. . . ] During the memory station performing, press 1-6 digital buttons to select and stop scanning function. (2)In MP3 mode, press A. P button repeatedly to select TRACK SEARCH, FILE SEARCH or CHARACTER SEARCH mode. BAND BUTTON Press it repeatedly to select your desired radio band during RADIO mode. CLOCK BUTTON Press CLK button to display time on LCD, then press CLK button hold until time flashes on LCD, thirdly press + or - button to adjust HOUR or MINUTE. [. . . ]