User manual PYLE PLCM4235

[. . . ] Press it hold for more than 2 seconds can have LOUD mode. LOUD MODE: When reduce the volume to half level, press it to enhance the bass effect. For Mp3 playing (MP3 model only), this button can act as the ENTER key. To memorize the current frequency, press any one of the six preset Buttons hold for more than 2 seconds. [. . . ] CLOCK BUTTON Press it to display time on LCD for few seconds. Press it hold and then press button to adjust hour or minute. AF BUTTON (for RDS model only) AF [ALTERNATIVE FREQUENCIES] When pressed short, AF switching mode is selected and the state of AF switching mode is displayed by AF segment in display. Segment on: AF switching mode on, and has RDS information. Segment flashing: AF switching mode is selected, but RDS information is not received yet. When AF switching mode is selected, the radio checks the signal strength of AF all the time. The interval of checking time of each AFs depends on the signal strength of current station, from a few minute for strong station to a few seconds for weak station. Everytime that new AF is stronger than current station, it switches over to that frequency for very short time, and NEW FREQUENCY is displayed for 1-2 second. Because the mute time of AF switching or checking time is very short, it is almost inaudible in case of normal program. When pressed long, it is activated of regional mode on /off . Regional mode ON AF switching or PI SEEK is implemented to the station which have all PI codes are the same as current station. REG of individual segment is turned on also together with displaying REG ON numeric display for a few seconds. Regional mode OFF The regional code in the format of PI code is ignored when AF switching or PI SEEK is implemented. is turned off together with displaying REG OFF on numeric display for a few seconds. And then 6 strongest stations are preset to the corresponding preset number. The AS operation is implemented in the each band of selected band. When the AS operation is finished, the radio executes the preset scan. In MP3 mode, press 0-9 and ENTER button to play the track in 1-108 number. MODE BUTTON Press it repeatedly to select CDP, AUX and RADIO mode in sequence and circulation. For SUB WOOFER function(optional), press and hold for more than 2 seconds can have WOOFER Mode. For Mp3 playing (MP3 model only), this button can act as the digit 7 key. POWER BUTTON Press it to turn on or off the unit. MUTE BUTTON Press it to eliminate the sound immediately. DSP BUTTON Press it to switch between 4 preset equalizer curves: FLAT, CLAS, POP M, ROCK M. SCAN BUTTON Press it to scan up by one channel step with station detection. If a valid signal has detected, the current frequency is blinked within 5 seconds, then press it again to stop scan and remain the current frequency; otherwise, the unit continue to scan up by one channel step with station detection 5 seconds later. [. . . ] Press the OPEN button to flip down the front panel (see fig. 1), then take away the front panel (see fig. 2) and put it in the protective case (see fig. 3) safe keeping. Install the front panel back into its bracket and then push it back to the position for playing (see fig. 4). FRONT PANEL FRONT PANEL OPEN BUTTON ( FIG. 1) ( FIG. 2) PROTECTIVE CASE FRONT PANEL FRONT PANEL ( FIG. 3) ( FIG. 4) 8 DISC NOTES DISC PLAY: Cleaning discs Before playing, clean the disc with a clean, lint-free. Flip the disc in the direction of the arrow. NOTE: Do not use so solvents such as benzine, thinners. [. . . ]