User manual PYLE PLDVD128

[. . . ] Be careful not to drop or shock the unit strongly. Do not touch the liquid crystal to avoid the life hurt. If the clothes is stained with it, Please clean it immediately by soap. [. . . ] Press DSP button twice to effect [POPS] volume, LCD shows CLASSICE on. Press DSP button third to effect [CLASSIC] volume, LCD shows POP on. Press DSP button fourth to effect [FLAT] volume, LCD shows FLAT on. Press DSP button again to resume the normal listening. Short press CLK can display time even power off . Long Press CLK for 3 seconds will enter set mode. 6 SELECT VOLUME PWR VOL SEL SEEK SCN RPT RDM STOP N/P BAND CLOCK MODE DSP 1 2 3 4 5 6 PLAY/PAUSE SCAN REPEAT RANDOM STOP N/P Press SEL/VOL button once, display will show VOL on, then rotate the button in clockwise direction to increase volume level;rotate the button in anticlockwise direction to decrease volume level. VOL Press SEL/VOL button third, display will show TRE on, then rotate the button to adjust treble level up/down in different direction. SEL Press SEL/VOL button twice, display will show BAS on, then rotate the button to adjust bass level up/down in different direction. Press SEL/VOL button fourth, display will show BAL on, then rotate the button to adjust left and right speakers level up /down in different direction. Press SEL/VOL button fifth, display will show FAD on, then rotate the button to adjust front and rear speakers level up/down in different direction. 7 If with DISC in unit, Press the [ Press the [ ]to pause music. ]button again , come back DISC playing. Press this button to play all the track in random order. This button is invalid if the unit is in PBC On mode. If a disc is loaded, a sector sign will show on the display. Press STOP button to stop music, and press to start playing from track one. button Press this button once for TRACK INTRODUCTION. The first 10 seconds of each track on the disc will play. To select a desired song, press [SCN]button while it is playing. In video mode, press this button to exchange between the PAL and NSTC. Press the button to repeat the same track continuously, RPT will appear on the LCD display. Press the button again to come back normal playing. 8 SEEK- PWR VOL manual tuning: SEL SEEK SCN RPT RDM STOP N/P BAND CLOCK MODE short press Short press button it can select higher frequency station. can select lower frequency station. DSP 1 2 3 4 5 6 PRESET MEMORY 1-6 BAND SEEK+ long press button can automatically select higher frequency station. And long press can automatically select lower frequency station. Press BAND button to select among three FM or two AM bands. [. . . ] EUROPE:522-1620KHz (9KHz step) USA:520-1720KHz (10KHz step) AM sensitivity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28dB 22 What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. Confirm whether the lead short circuit, then replace fuse with same capacity. Check the speaker wiring and test the speakers all in good condition check the setting of volume, Balance and Fader controls. Exactitude connect of the cable. Adjust the unit with mounting angle less than 45 and make sure the unit is mounted securely and tighten with the back strap(supplied) Check antenna and antenna cable, the antenna base must be grounded and connected with good condition, replace antenna or antenna cable if needed. Check the Red wire to +12 Volts with key lgnition witch, yellow wire to +12 Volts battery and black wire to ground. [. . . ]