User manual PYLE PLDVD189

[. . . ] Failure to observe this may cause malfunction due to the precise mechanism of this unit. Use Authorized Service Centres Do not attempt to disassemble or adjust this precision product. Please refer to the Service Centre list included with this product for service assistance. For Installation The unit should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30 . USE THIS PRODUCT SAFELY When Driving Keep the volume level low enough to be aware of road and traffic conditions. [. . . ] The player will start playback automatically. 2 3 1 Ejecting a Disc Press button (3) on the front panel or to (EJECT) button on remote controlto eject the disc. 15 OPERATION BASIC OPERATION SWITCHING ON/OFF THE UNIT Press PWR button on the front panel or POWER button on the remote control to turn on the unit. MUTE Press MUT button on the front panel or MUTE button on the remote control to mute down the sound instantly. Pres it again to resume sound output. FACEPLATE RELEASE Press button on the front panel to detach the removable faceplate. EQUALIZATION Press EQ button shortly to turn on equalization function and to select desired audio mode. There are three kinds of mode as below: CLAS POP ROCK SOUND ADJUSTMENT Press SEL button on the front panel of the unit or on the remote control to select the desired adjustment mode. The adjustment mode will change in the following order: VOL BAS TRE BAL FAD (Volume) (Bass) (Treble) (Balance) (Fader) MODE SELECTION Press MOD button on the front panel of the unit or MODE button on the remote control to select among radio, disc (DVD/VCD/CD/MP3) play mode and AV IN mode. By pressing the VOL /VOL buttons on the front panel or VOLUME +/buttons on the remote control, it is possible to adjust the desired sound quality. LOUDNESS Press and hold BND/LOU button on the font panel for several seconds or press LOUD button on the remote control to reinforce the bass output. Press BND/LOU button on the font panel for several seconds again or press LOUD button on the remote control again to release this function. LIQUID CRYSTAL DISPLAY Exhibit current frequency and activated functions on the display of the front panel. FLASHING LED If the front panel does not install in the main unit, the LED will be flashing. REMOTE SENSOR Point the remote control handset to the remote sensor RX. Press the function keys on the handset to control the system. RESET FUNCTION RESET button on the housing must be activated with either a ballpoint pen or thin metal object. The RESET button is to be activated for the following reasons: SET THE CLOCK Press the DSP button on the front panel, the clock is shown on the LCD display. Then hold down the button until the clock flashes. Then press the VOL button on the front panel or VOLUME + button on the remote control to change hours; press VOL button on the front panel or VOLUME button on the remote control to change minutes. 16 OPERATION - Initial installation of the unit when all wiring is completed. When you unmute the sound (press MUT or MUTE again), sound will resume. REPEATING PLAYING FOR DVD: Press RPT button on the front panel or on the remote control to select repeat mode as follow: CHAPTER REPEAT ON TITLE REPEAT ON REPEAT OFF FOR VCD/CD/MP3: Normal playback 1X 2X 3X 4X SKIPPING TRACK Press MANU/SKIP / buttons on the front panel or / buttons on the remote control during playback. Press or to skip to next track, and or to back one track. Note: For some VCD2. 0 discs (PBCplayback control), / or / buttons may be unavailable. SLOW MOTION PLAY Press SLOW button on the remote control during play. Each time the button is pressed, the speed of slow forward changes according to the disc as follow. FOR DVD: Normal playback 2X 4X 8X FOR VCD/CD: Press RPT button to select repeat mode as follow. REP-ONE REPEAT OFF 1. Continuously repeat the current chapter/track, when REP-ONE mode is selected. When the player finishes playback of the current disc last chapter/track, it will stop and display the elapsed time. When REPEAT OFF mode is selected, REP-ONE disappears from screen display. REPEAT feature does not support VCD2. 0 (with PBC ON). 18 OPERATION REPEATING PLAYING A PASSAGE A-B repeat allows a passage to be repeated continuously. [. . . ] NO PICTURE Check if the monitor or TV is switched on. Check if select proper mode, such as Disc Play mode and AV mode. DISTORTED PICTURE Check the disc for fingerprints and clean with soft cloth, wiping from centre to edge. Sometimes a small amount of picture distortion may appear. [. . . ]