User manual PYLE PLDVD7M

[. . . ] Use Authorized Service Centres Do not attempt to disassemble or adjust this precision product. Please refer to the Service Centre list included with this product for service assistance. For Installation The unit should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30°. USE THIS PRODUCT SAFELY When Driving Keep the volume level low enough to be aware of road and traffic conditions. When Car Washing Do not expose the product to water or excessive moisture. [. . . ] You can sometimes improve reception of distant stations by selecting mono operation. SCAN Press ENT/MUT button on the front panel shortly to set the function to scan mode, which scanning to higher frequency station with receivable signal and keep on each station for several seconds. SELECTING STATION During radio mode, shortly press CH/TUN/TRK button on the front panel or button on remote control to increase frequency by one step of channel spacing, and shortly press CH/TUN/TRK on the front panel or button on remote control to decrease frequency by one step of channel spacing. Hold CH/TUN/TRK / buttons on the front panel longer or press / buttons on the remote control for fast tuning. The frequency is updated correspondingly on display. LOCAL/DISTANT Press ST/XM-MOD button on the front panal or remote control for several seconds to select between local and distant stations. Local setting for reception of strong station, and a distant setting for reception of weaker stations. This function is effect during AUTO SEEK operation. AUTOMATIC MEMORY STORING & PROGRAM SCANNING - Automatic memory storing Press and hold AMS button on the front panel or on the remote control for several seconds, the radio searches from the FM1 the initial frequency and checks the signal strength until one cycle search is finished. And then 6 16 XM OPERATION SWITCHING TO XM MODE Shortly press MOD button to select XM mode. SELECTING USER-PRESET CHANNEL In XM mode, the XM user-preset channel group (3 channels) is toggled cyclically through the group by quickly pressing the BND/MEN button. The channel will change in the following order: XM1 XM2 XM3 SELECTING CHANNEL UP/DOWN Press the CH/TUN/TRK button or CH/TUN/TRK button to select the channel up or down. In Category mode, channels can be tuned within the same category. - When the user wishes to search by Category, press ST/XM-MOD button until it goes into Category search mode. - Press M6 button or M5 button up and down to get to the desired category. - To change channels, press ST/XM-MOD button again to Normal mode, and then press CH/TUN/TRK button or CH/TUN/TRK button to select the channel up or down. In direct mode, display shows DIRECT and "000" channel number. (Hundred Digit flashing on/off) 17 FOR VCD/CD: Normal Playback 1X 2X 3X 4X SKIPPING TRACK Press CH/TUN/TRK / buttons on the front panel or / buttons on the remote control during playback. Press or to skip to next track, and or to back one track. Note: For some VCD 2. 0 dics (PBC-playback control), / or / buttons may be unavailable. SLOW MOTION PLAY Press / button on the remote control OPERATION during play. Each timEach time the button is pressed, the speed of slow changes according to the according to the disc as follow. FOR DVD: Normal Playback 2X 4X 8X FOR VCD: Normal Playback 1X 2X 3X REPEATING PLAYING A PASSAGE A-B repeat allows a passage to be repeated continuously. [. . . ] · Check if the on/off button on the front of the player is set to on. NO PICTURE · Check if the monitor or TV is switched on. · Check if select proper mode, such as Disc Play mode and AV mode. DISTORTED PICTURE · Check the disc for fingerprints and clean with soft cloth, wiping from centre to edge. [. . . ]