User manual PYLE PLDVDMP4

[. . . ] Use Authorized Service Centres Do not attempt to disassemble or adjust this precision product. Please refer to the Service Centre list included with this product for service assistance. For Installation The unit should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30°. USE THIS PRODUCT SAFELY When Driving Keep the volume level low enough to be aware of road and traffic conditions. When Car Washing Do not expose the product to water or excessive moisture. [. . . ] There are five kinds of mode as below: 15 OPERATION RADIO OPERATION SWITCHING TO RADIO MODE Press MODE on the front panel or MODE on the remote control to select radio mode, the radio mode appears in the display together with the memory band and frequency. SELECTING THE FREQUENCY BAND During radio mode, shortly press MENU (BAND) button on the front panel or BND (MENU) button on the remote control to select the desired band. The reception band will change in the following order: FM1 FM2 FM3 AM1 AM2 panel or on the remote control for several seconds, the radio searches from the FM1 the initial frequency and checks the signal strength until one cycle search is finished. And then 6 strongest stations are stored into the corresponding preset number button. - Program scanning Press AMS button shortly to scan preset station. STATION STORING Press any one of the preset buttons (1 to 6) on the front panel to select a station, which had been stored inthe memory. Press this button for several seconds, current station is stored into the number button. MONO/STEREO Press ST/LOC/TITLE button on the front panel or ST/TITLE button on the remote control shortly to select mono or stereo mode. You can sometimes improve reception of distant stations by selecting mono operation. SCAN Press MUT/ENT button on the front panel shortly to set function to scan mode, which scanning to higher frequency station with receivable signal and keep on each station for several seconds. SELECTING STATION Press / buttons on the remote control or / buttons on the front panel shortly to activate automatic seek function. Press and hold / buttons for several seconds until "MANUAL" appears on the display, the manual tuning mode is selected. Press ZOOM button on the remote control to toggle among 1. 5 scale, 2. 0 scale and 3. 0 scale. When the scale is 3 times, press ZOOM button again to cancel the zoom function. 1. 5X 2. 0X 3. 0X Cancelled FOR VCD: Normal Playback 1X 2X 3X PAUSING PLAYING Pressing on the remote control or on the front panel during playback will stop play temporary. To return to normal playback, press once again. 17 During Zoom mode, press / , / buttons to move pictures up, down, left or right direction. REPEATING PLAYING A PASSAGE A-B repeat allows a passage to be repeated continuously. Press A-B button OPERATION on the remote control at the start of the required passage, then press A-B button again at the end of the passage. To revert to normal playing, press A-B button again. Each time the button is pressed, the screen will display as follows: A TO B SET A A TO B SET B A TO B CANCELLED PREVIEWING PLAYING (ONLY FOR VCD/CD/MP3) Press SCN button on the front panel to play first several seconds of each track on the current disc. Press again to stop intro and listen to track. PLAYING IN PROGRAMMED ORDER For CD/VCD (WITH PBC OFF): Press the STOP button twice to ensure that the player is in STOP mode. Then press PROGRAM button, the screen will display "PROGRAM P00:00". For example: press numeric button 4, "PROGRAM P01:04" appears, it means track 4 will be played first, then press numeric button 6 and "PROGRAM P02:06" appears. [. . . ] · Check if the on/off button on the front of the player is set to on. NO PICTURE · Check if the monitor or TV is switched on. · Check if select proper mode, such as Disc Play mode and AV mode. DISTORTED PICTURE · Check the disc for fingerprints and clean with soft cloth, wiping from centre to edge. [. . . ]