User manual PYLE PLPSE5

[. . . ] NOTE: Most speaker terminals are either color-coded or have a mark that indicates the terminal's polarity. Usually positive terminals are red or have a plus symbol (+), and negative terminals are black or have a minus symbol (-). Connect the speaker wires to the amplifier's left and right speaker terminals according to the terminal color polarity. MONO OPERATION SWITCH IN "MONO" POSITION CH B CH A MONO STEREO BRIDGE Connecting to standard AC power After making all other connections, set the POWER switch to OFF position. [. . . ] Mounting the amplifier This amplifier is designed to accept standard rack mounting installations. Two slots on each end of the front panel make it suitable for such an installation. Tightly secure four mounting screws (not supplied) through these fours slots and into your standard electronics equipment rack. INPUTS CH B CH A CH B CH A OUTPUT PREAMP OR MIXER CH A CH B CH A + + ­ INPUTS CH B CH A ­ AC POWER IN + BRIDGE CH B CH A GND GROUND GROUND LIFT LIFT MONO STEREO BRIDGE ­ CIRCUIT BREAKER CH B OUTPUT + + CH A ­ LOW CAPACITANCE SHIELDED WIRE GROUND SCREW ­ AC POWER IN GND GROUND + BRIDGE Input connections These amplifiers accept a broad range of input sources, including Compact Disc (CD) players; Cassette, Reel-to-Reel or other tape players; Radio Tuners; Equalizers; Signal Processors. Connecting a CD or tape player or tuner In a normal installation, one would use the RCA JACKS for connecting a CD player, tape player or tuner. ­ CIRCUIT BREAKER CH B GROUND LIFT LIFT MONO STEREO BRIDGE Turning the amplifier on 1. Turn on the audio input source equipment which is connected to the amplifier INPUT jacks. Set the amplifier's Channel A and Channel B output level gain controls to the minimum level settings. Push in the power switch to turn the amplifier on. Using the power meters The meter pointer position indicates the amplifier output power. For ease of reading in dark environments, the meter is illuminated. · Wipe occasionally with a damp cloth to keep it looking new. Do not use harsh chemicals, solvents or detergents!Resetting the circuit breaker This amplifier employs a circuit breaker for protection from power surges and short circuits. If the amplifier suddenly turns off or will not turn on, check the circuit breaker. If it is tripped, check and correct for a short or overload condition. Wait for the amplifier to cool, then press the circuit breaker RESET button on the back of the amplifier. Limited Warranty All PYLE PRO products are carefully constructed and tested before shipment. Units purchased in the USA are warranted to be free of defects in material and workmanship for two (2) years from the date of purchase. This warranty is limited to the original retail purchaser of the amplifier. Should the unit fail due to factory defects in material or workmanship, your unit will be repaired or replaced at the sole discretion of PYLE. [. . . ] Should the unit fail due to factory defects in material or workmanship, your unit will be repaired or replaced at the sole discretion of PYLE. To obtain warranty service, you must first call our Consumer Return Hotline at (718) 236-6948 to obtain a Return Authorization Number. # must appear on the outside of your package and on all paperwork relating to your return. [. . . ]