User manual PYLE PLTK100N

[. . . ] Make all required audio, video and power connections to the appropriate connectors on the tuner as indicated in the drawing below to suit your system installation. Install the infrared remote eye in a location you know will be Installation in line-of-sight with the remote control use location Please note that the drawing below describes connections for all system possibilities and your particular system may vary from this. For example, if your car radio lacks AUX line level input jacks, you will be unable use the A/V VIDEO OUT jacks to provide audio. In this case, you can take advantage of the built-in FM transmitter in the tuner box which will broadcast the audio to your car radio instead. [. . . ] Note that the antenna module contains one antenna in a fixed position and one which may be adjusted. Place one antenna on the right edge of the roof of your car at about the midpoint of the length of the roof. Orient the antenna so that the fixed antenna is closer to the centerline of the vehicle. Now adjust the repositionable portion of the antenna so that there is about a 15 angle between it and the fixed antenna portion. Repeat this procedure with the other antenna module, again with the fixed antenna closer to the centerline of the vehicle. Plug the jacks at the ends of the cables from the antennas into the antenna jacks on the tuner according to the diagram shown on page 2 of this manual. The diversity antennas provided with your system use powerful magnets option. Option 13 Powering up the system 1. Press and hole the POWER On/Off button on the remote until the green LED on the front of the monitor is illuminated. The On Screen Display will show the position of the system at the time it was last turned off (for example, if you were watching CATV Channel 38 when you last turned the power off, the system will display "CATV CH 38"). Turn off the system by pressing the POWER On/Off button on the remote. The screen will go dark and the green LED will go out; the tuner unit will be in STANDBY mode. TV/CATV TV/AV MUTE POWER 1 5 9 VOL 2 6 0 CH 3 7 FM/AM 4 8 SETUP Monitor + - UP FUNC DN MODE Selecting the input Mode Your Video Tuner can switch between four different video sources using the remote control. These modes are as follows; TV Mode: for receiving TV Channels 2-69 TV/CATV TV/AV MUTE POWER 1 5 9 VOL 2 6 0 CH 3 7 FM/AM 4 8 SETUP CATV Mode: for receiving satellite dish, Cable or other broadcast source video AV1:External audio and video inputs for DVD, VCR or video game AV2:External audio and video inputs for DVD, VCR or video game Monitor + - UP FUNC DN MODE Programming Channels for TV/CATV The tuner system can memorize channels in both TV (VHF and UHF) mode and CATV mode in two independent memory sections. To memorize channelss in either mode, press the AUTO PROG button on the remote-the tuner will begin scanning all of the available channels and put them int memory. During this programming cycle, the screen will display "AUTO"in the upper left corner. IF you wish to interrupt the auto programming mode. Interrupting in this manner is not recommended, however, because it will not program all channels properly. TV/CATV TV/AV MUTE POWER 1 5 9 VOL 2 6 0 CH 3 7 FM/AM 4 8 SETUP Monitor + - UP FUNC DN MODE Selecting Channels Use the Channel and buttons for selecting channels. [. . . ] To use this system tune your car radio from FM 88. 1 to FM 99. 9 for 20 channels the on you're A/V audio source. You should be able to hear your A audio broadcast through your car radio system. V If you do not, go back into the Fm CHANNEL mode of the menu system and select FM 88. 1 MHz to FM 91. 9 MHz by channel step 0. 2 MHz, , and exit the menu system. [. . . ]