User manual PYLE PLTV64R

[. . . ] When you operate the display unit, do not touch the display by your hands. It may harm your fingers. 3 INSTALLATION Notes: · Choose the mounting location where the unit will not interfere with the normal driving function of the driver. · Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. · Use only the parts included with the unit to ensure proper installation. [. . . ] Press it again to resume the previous volume mode. · SETTING THE CLOCK Press T/F button (5) to change the display into clock display. While the current time is appeared on the display, press it again to return to frequency showing. Time Setting - Set hours: Holding down T/F button (5) for several seconds, and the clock is blinking on the display, press TUNE/SKIP button (14) to adjust the hour. - Set minutes: Holding down T/F button (5) for several seconds, and the clock is blinking on the display, press TUNE/SKIP button (13) to adjust the minutes. · LIQUID CRYSTAL DISPLAY The LCD (4) can show the current state of the unit. · RESET Reset button (9) must be activated with either a ball point pen or thin metal object. The reset button is to be activated for the following reasons: - Initial installation of the unit when all wiring is completed. - All the function buttons do not operate. - Error symbol on the display. 10 Volume Adjust volume level using VOL and VOL (8) buttons. (7) Bass Press SEL button (6) for one time. Adjust bass level using VOL (7) and VOL (8) buttons. Treble Press SEL button (6) for two times. Adjust treble level using VOL (7) and VOL (8) buttons. Balance Press SEL button (6) for three times. Adjust sound balance between left and right speakers using VOL (7) and VOL (8) buttons. Fader Press SEL button (6) for four times. Adjust sound balance between front and rear speakers using VOL (7) and VOL (8) buttons. · SELECTING PLAYING MODE When the screen display is drawn in, press MOD button (12) to select desired playing mode between radio and CDC. When the screen display is drawn out, the unit will automatically switch into TV mode. OPERATION RADIO OPERATION · SELECTING BAND Press BND button (11) to change between three FM bands and two AM bands and one LW band. Each band stores up to six preset stations. FM1 FM2 FM3 AM1/MW AM2/LW · SELECTING STATION During radio mode, press TUNE/SKIP button (13) to increase frequency or TUNE/SKIP button (14) to decrease frequency by one step of channel spacing. The frequency is updated correspondingly on display. · SELECTING MEMORY Press preset memory buttons (15) to preset stations at tuner mode. [. . . ] Note: In the menus (except TUNER MENU), if you don't operate over 6 seconds, the screen display will disappear. 13 OPERATION · VOLUME ADJUSTMENT Press VOL + button (32) or VOL ­ button (33) to adjust volume level. · MUTE Press MUTE button (25) to mute the sound. Press the button again, the screen will display "VOLUME XXX" for about 4 seconds, and this is the AUDIO level setting value of the TV unit. The users may not mind it, and that adjust the volume level by VOL + (32) and VOL ­ (33) buttons. [. . . ]