User manual PYLE PLTVCP85

[. . . ] VIDEO CASSETTE RECORDER WITH BUILT-IN TV TUNER PLTVCP85 CAUTIONS AND WARNINGS To obtain the best results and to avoid malfunctions, PLEASE READ CAREFULLY THE DESCRIPTIONS AND OPERATING PROCEDURES CONTAINED IN THIS OWNER'S MANUAL PRIOR TO OPERATING THE VIDEO CASSETTE RECORDER. CAUTION RISK OF ELECTRIC SHOCKS DO NOT OPEN CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This user manual employs the following symbols to indicate different types of warning messages. Indicates the presence of uninsulated dangerous voltage within the unit enclosure. Indicates a warning or notice regarding product operation. [. . . ] The unit will not operate unit it dries out sufficiently ( the tape can be ejected from the unit). When DEW mode has been activated, leave the unit on the allow it to dry out completely. 11. Hi-Fi Lamp In the Hi-Fi out mode, the lamp will light up in red. 12. Auto Repeat Lamp During Auto repeat operation, Auto Repeat lamp will light up in red. 13. Audio/Video In Jacks (AV2) Connect these jacks to the audio/video out jacks terminal of your game machine or camcorder using the RCA cord. For displaying this Front A/V lnput connected, Input Signal should be set to " AV2" in Menu setting mode. 7 REAR PANEL-CONNECTIONS AND POWER 6 1 2 34 5 7 1. AUDIO/VIDEO IN (AV1) Connector this terminal to VIDEO/AUDIO OUT terminal of your Game machine, Camcorder, Portable DVD Player, using the RCA cord For displaying this Rear A/V input connected, Input Signal should be set to "AV1" in Menu setting mode. AUDIO/VIDEO OUT Connect this terminal to VIDEO/ AUDIO IN terminal of your TV (or Amplifier/Monitor), using the RCA cord provided. IR INPUT Connect this terminal to Remote IR Sensor cable provided. 8 4. DC 12V IN JACK (Locking type) For car using, we recommend to use this connecter with 3-wire system. * Connector description for 4 ACC 12V GND VEHICLE BATTERY 12V 5. DC 12V IN JACK ( Round type) To use this connector, below Convert-Adapter accessory should be locked into above connector 4. ( Convert-Adapter) * Please note : We highly recommend to connect the unit corresponding to the 3-wire system of 4. Thus, to make sure a proper working of power-off tape guide. Beyond it, the unit will automatically change to standby mode after turning off the vehicle in order to save the car battery. 6. ANT IN (TV/CATV) Connect the TV antenna (or cable if available- home use) to this connector. RF OUT This connectors provides an interface to the antenna input connectors terminal of your television using a coaxial cable. Set TV to channel 3 or 4 to watch video tapes. 9 REMOTE CONTROLLER 1. To watch the desired picture once more during playback, press "ENCORE" key . The VCR unit rewinds the tape for 5 seconds and will play the picture watch again. To watch the picture from start position of tape, press "REPLAY" key . The VCR unit rewinds the start position of tape. TRACKING -, + (Manually Tracking in playback mode) / CHANNEL -, + ( in TV or CATV mode) 5. [. . . ] Tracking is not adjusted. POSSIBLE SOLUTIONS Check the power cord. Adjust the picture to be clear by pressing the Re-tracking. Turn off the power and turn on the power again by pressing the POWER cord. Pull the cassette out (unloading) and insert it firmly into the cassette compartment. [. . . ]