User manual PYLE PLTVRD10

[. . . ] Improper use can result in electric shock or fire hazard. The safeguards incorporated in this unit protect you if you observe the following procedures for installation, use and servicing. This unit doesn't contain any parts that can be repaired by the user. 2. The monitor is operated automatically. [. . . ] Notes: The external remote receiver is placed near the monitor for the best to receiver remote signal easily. If the angle of the monitor from vertical exceeds 20 (Especially the distance exceeds 3m. ), controlling the TV through IR (10) or (26) cannot get good effect. You are suggested to use the external remote receiver. LIQUID CRYSTAL DISPLAY The LCD (4) can show the current state of the unit. 6. 5 inch TFT DISPLAY When the monitor stretches out, the 6. 5 inch color TFT display (5) can show the current state of the unit. RESET FUNCTION Reset button (9) must be activated with either a ballpoint pen or thin metal object. The reset button is to be activated for the following reasons: Initial installation of the unit when all wiring is completed. All the function buttons do not operate. Note: When the monitor stretches out and on the central viewing position, activate the reset button (9), the monitor will turn downward and draw in automatically. OPERATING WHEN THE MONITOR NOT STRETCHING OUT When the monitor doesn't stretch out, the front panel of the unit is in state A (see Fig. A), you can operate the unit following the instructions below. Sound mode selection Press SEL button (6) on the front panel or MENU button (45) on the remote control to enter sound mode then pres sTUNING / buttons (13&14) or TUN/CH / buttons (46) to switch between volume, bass, treble, balance, fader, loud and equalization mode. Repeating the same track Press RPT button (30) on the front panel to continuously repeat the same track on the current disc. Playing all tracks in random Press RDM button (31) on the front panel to play all tracks on the current CD in random order. In the course of playing a track, press TUN/CH / buttons (46) to play another track in random order. Selecting disc Press CD+ button (33) on the front panel to select next disc and press CD- button (32) on the front panel to select previous disc. Automatic memory storing & program scanning - Automatic memory storing Press AS/PS button (48) for several seconds, the radio searches from the current frequency and checks the signal strength until one cycle search is finished. And then 6 strongest stations are stored into the corresponding preset number button. - Program scanning Press AS/PS button (48) shortly to scan preset station. When the field strength level is more than the threshold level of stop level. The radio is holding at that preset number for several seconds with release mute, then searches again. Local/distant Press LOC button (38) on remote control to select between local and distant stations. Local setting for reception of strong station, and a distant setting for reception of weaker stations. This function is effect during AUTO SEEK operation. [. . . ] Selecting receiving mode In TV mode, press TV/AV button (21) or (41) to select among TV/ AV1/AV2/ RGB (optional). The corresponding state will show on the TFT display (5). When you connect the RGB terminals on the back of the unit to the corresponding RGB system, then press MODE button on remote control to select RGB mode, the RGB signal will appear on the screen. Note: You can receive the TV/AV1 /AV2 mode when you brake the car. [. . . ]