User manual PYLE PLVHR85M

[. . . ] Do not use this unit temperatures under 5 oC (41 oF) or over 45 oC (113 oF). If your car was parked in a clod or hot place, the picture may not be clear. The picture will become clear after temperature in your car becomes normal. 5. Some stationary blue or red dots may appear on the monitor. [. . . ] When replacing the fuse, be sure to use one that matches the amperage described on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case, consult your nearest your's dealer. White RCA: Mono Audio Input Yellow RCA:Video Input Red wire :DC +12Volts Power Input ( car battery ) Black wire: Ground (negative earth) Replacing the Remote Control Batter y 1)Always use new battery when replace the old set. 2)Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries, battery may be explode PULL OUT if mistreated. PUSH IN 3)Battery replacement is necessary when remote control acts sporadically or stops operating. 4)Do not drop, apply shock or step on the remote control. 5)Do not spill water on the remote control. 6)Do not place objects between the remote control and remote sensor. 7)Do not use remote control for the other equipments at the same time. 8)Do not leave the remote near any heat sources, or in a place subject to direct sunlight (especially on the dashboard). Repeat this procedure for the other two corners. Remove foam & obstructions Carefully peel off the material. Set the adjustable blade to one inch depth and cut around the edges of the hole, staying 1/4 inch inside the edge. Pull up one corner of the foam and use the blade to cut underneath. Remove small section at a time, ensure to be the uniform depth . Use a dremel or other appropriate tools to remove other obstructions. Insert the monitor to measure the fit and make adjustment if necessary. 9 Route the cable through the visor Run the supplied cable through the opening and out to the bottom of the visor. If possible, conceal the wires using a shaft covering. Connect the power, ground and video leads to test the MONITOR. Before connecting the monitor, pull the connecting cable assembly through the visor housing as shown in diagram. Place sun-visor shroud into the opening and secure it with correct fasteners. Install the sun-visor shroud Pull the connecting cable through the center of the housing as shown in diagram, and secure the sun-visor shroud with correct fasteners THIS SIDE UP THIS SIDE UP Insert the monitor Push to insert the monitor to the sun-visor shroud. Removal Insert the release key between the monitor and visor shroud gap and pull it out to remove the monitor from headrest shroud. Oper ate your syst em in a saf e and legal manner When oper ate a motor vehi cle, it shoul d always be your highest priority to maintain saf e driving habi ts. [. . . ] Press button 1 to confirm setting. [Saturation adjustable level: 0~100 . Preset: 50] Saturation 50 2 1 -/+ Video Signal MU EXIT SAVE / EXIT Remote OSD Setup Others 3 Monitor Picture Parameters DDP OSD Press the button( 2or3) to adjust the symbol to choose "gamma". Press menu button (1) to enter gamma setting. [Gamma: Makes black light appear darken or lighter] Contrast Brightness Hue Saturation Gamma Function Scaling Return 5 2 1 SEL. MU ADJ. EXIT RET Remote 3 16 Monitor Video Signal Picture Parameters DDP OSD Setup Others OSD Press button 2: appear 0 standard (preset). Press button 1: to confirm setting. Gamma Function 0 2 1 -/+ MU EXIT SAVE / EXIT Remote 3 Monitor Video Signal Picture Parameters DDP OSD Setup Others OSD Press the button( 2or3) to adjust the symbol to desired setting (scaling). [. . . ]