User manual PYLE PLVW1342R Instruction Manual

[. . . ] Specifications Screen Size: System: Display Method: Power source/Consumption: Storage Temperature: Display Method : Monitor dimension: Pixs: Weight: Cautions Never connect the car adaptor to cigarette lighters for such as trucks o buses which use 12V DC power. r Do not expose the monitor to high humidity, dust, steam, oily smoke, direct sunlight etc. [. . . ] SAFETY FIRST FOR REAR SEAT USE ONLY . Do not install on dashboard or any where else that would permit monitor to be viewed by the driver . Monitor must never be used in any manner that will distract driver or interfere with the drivers safe operation of the monitor vehivle. Be careful not to run down the car battery while using the set with the car stopped. Do not disassemble or modify the set . Doing so may damage it and voids your warranty. Keep drinks and drops from numberllas away from the set . Water may damage the internal circuitry. Do not let the set become hot . If temperature in the car is high or the set has been exposed to direct sunlight and is hot , lower the temperature before using it . In extremely cold temperature , the movement of the picture may be slow and the picture may be dark , but this is not a malfunction . The set will work normally once the temperature increases. Battery tank Battery Transparent slice 1. Always use new batteries when replacing the old set . Do not attempt to charge , short-circuit , disassemble , heat or burn used batteries. 3. Battery replacement is necessary when remote control acts sporadically or stops operating this device. 4. Do not place objects between the remote control and remote receiver. 5. If the monitor does not operate even when operating the remote control from a colse rangre , it is time to replace the batteries Product number :(cr2025) INSTALLATION The device is an overhead , fold-down 13 inch monitor with an infrared ir eye . It will accept a video signal from any video source with composite videout . 1. Look over the vehicle for a location for the monitor . Each vehicle is different and locations will vary . Make sure the monitor will not interfere with the driver. [. . . ] 2. When creating passage holes for the power wires , use grommets to eliminate any sharp edges created during drilling . This will protect the wire from being nicked and causing a short circuit . 3. When connecting the ground lead , fasten the ground lead(black) securely to a clean metal plate on the vehicle . 11 12 1 2 3 4 5 6 7 8 9 1. LED 3. AV1 5. + 7. 9. IR 11. Monitor release button 2. Power 4. AV2 6. MENU 8. RSI 10. Dome light 12. Dome light switch 4 REMOTE CONTROL 1. Power ON/OFF the monitor 2. Contrast positive adjustment 3. Switch between V1 and V2 4. Brightness positive adjustment 5. Brightness negative adjustment 6. Contrast negative adjustment 7. Saturation negative adjustment 8. Saturation positive adjustment 2 5 1 FUSE 2A Video1 input (yellow RCA) Video input2 (white RCA) 6 2 7 8 AV 3 12V BATTERY TFT-LCD MONITOR REMOTE PLAYER 3 Black Red [. . . ]