User manual PYLE PLVW1410IR

[. . . ] Closing Monitor -------------------------------------------------------7 11. OSD Menus in A/V Source ------------------------------------------- 8 12. Remote Control----------------- -------------------------------------- 9 13. Appendix--------------- ----------------------------------------------- 9 14. [. . . ] Do not use this LCD monitor in the areas susceptible to excessive dust, dirt, and humid. Do not setup the LCD monitor in direct sunlight, extremely hot, and cold environment. Do not expose the LCD monitor to rain or moisture. 2 Package This LCD monitor comes with all the items below. Contact your dealer immediately if anything is missing. * 14. 1" High RES TFT-LCD Wide Screen Monitor * Overhead Console Mounting Bracket * Credit Card Size Remote Control with Batteries * Interface Cable with RCA jacks for Audio / Video Connection and 12V DC * User's Manual * Warranty Card * Infrared Wireless Headphone User Control Overview * Panel Control POWER MENU UP DOWN MUTE 3 Function Descriptions * Power: * Menu: * / You may also turn on or off the monitor by this "Power" button. By pressing "MENU" button to pop up the OSD menus. Keys: 1. Press the " / " key to increase or decrease volume. Make item selection in OSD menus to increase or decrease parameters as well. Press the "Mute" button from the remote control to still the sound of the LCD monitor. * Mute: Start Your Installation * Monitor connection 4 Setting Up The Dome Lamps *Operating the dome Lamps 1. There are three function buttons for the Dome lamps operation: OFF, DOOR, and ON. DOOR: To make the lamps turned on only when car doors are opened. ON: To turn on the lamps. * The electric circuit figure OFF W B DOOR ON LAMPS R BATTERY + Point Power Cord Color R W B Red White Black Connection Connecting With Power Supply Connecting With Sensor of Car Doors For Ground Connection * Remarks: 1. There would be no any power cord puling out from "B" point as "B" have been connected with a ground connection by screws. Power supply should be used in 12 Voltages. 5 Installation your Monitor Take care to select a suitable fitting location and securing method for the monitor: *The unit should not distract or obstruct the driver. *The installation should not inhibit the entry to, or the exit from the vehicle. *The unit should not interfere with other vehicle components e. g. , (sliding sunroof). *Make sure the unit is installed to a secure, robust mounting location and cannot become dislodged in the event of an emergency stop. *Do not support the unit using only the vehicle interior roof lining. *If driving is required, take care not to penetrate through the other sheet metal of the vehicle. [. . . ] Press " " or " " button directly to adjust speaker volume. VOLUME 4. Select out of " EXIT" mode to storing your selected parameter and leaving OSD Menus. 8 Remote Control TV/CATV TV/AV MUTE POWER 1234 5678 90 FM/AM Monitor Power MUTE SETUP + VOL CH DN UP FUNC - MODE FUNCTION / OSD MENU UP MODE VIDEO1 / VIDEO2 DOWN Appendix Changing the New Battery in Remote Control 1. Push the cassette button to wards the right. Pull the all battery cassette away from the remote control. [. . . ]