User manual PYLE PLVW20T

[. . . ] Closing Monitor ------------------------------------------------------- 7 11. OSD Menus in A/V Source --------------------------------------------8 12. Remote Control----------------- ---------------------------------------9 13. Appendix--------------- ------------------------------------------------9 14. [. . . ] *The installation should not inhibit the entry to, or the exit from the vehicle. *The unit should not interfere with other vehicle components e. g. , (sliding sunroof). *Make sure the unit is installed to a secure, mounting location and cannot become dislodged in the event of an emergency stop. *Do not support the unit using only the vehicle interior fabric roof lining. *If driving screws is required, take care not to penetrate through the other sheet metal of the vehicle. *Avoid prolonged use of the monitor when the engine is not running to prevent draining the vehicle battery. *Place the mounting metal plate with the nuts facing upward, then, mount the monitor using the screws included. 6 Operating the Monitor * Powering up the monitor The monitor will be automatically turned on when releasing the monitor from the base unit and "OFF" when it is closed. Operating Instructions Opening the Monitor 1. Press the monitor release button to lower the LCD screen. Lower the monitor until is at the proper viewing angle. (Refer to the following figure. ) Closing Monitor 1. Return the monitor to the central viewing position. Push the monitor back into the monitor base unit until the screen engages with the release button. 7 * OSD Menus in A/V Source A. Source Selection Menu SOURCE MAIN MENU CUBS. 1 = NTSC H. SYNC = +60. 0Hz BRIGHTNESS CONTRAST COLOR HUE SOURCE AUDIO RECALL EXIT AUTO DETECT 1 2 VIDEO 1 VIDEO 2 RETURN B. Audio Input Selection Menu AUDIO MUTE VOLUME RECALL RETURN * Quick Adjustment OSD Menus 1. By pressing "MENU" button, you may open the MAIN MENU, using " " or " buttons to pick out OSD functions. In order to select desire options, it is necessary to press "MENU" again to enter each mode, than using " "/ " " to increase or decrease parameters as well. Press " " or " " button directly to adjust speaker volume. VOLUME 4. Press the " EXIT" mode to store your selected parameter and leave the OSD Menus. 8 Remote Control TV/CATV TV/AV MUTE POWER 1234 5678 90 FM/AM Monitor Power MUTE SETUP + VOL CH DN UP FUNC - MODE FUNCTION / OSD MENU UP MODE VIDEO 1 / VIDEO 2 DOWN Appendix Changing the New Battery in Remote Control 1. Push the battery case button to wards the right. Pull the battery case away from the remote control. As shown # 2 in below figure) Change a new battery. 2 Battery Cassette Button 1 9 Specifications 1. [. . . ] If your radio has AUX line-level inputs, you can attach the A/V Audio output connectors to these inputs with RCA-RCA interconnect cables. If your car radio lacks these AUX line level inputs, your other option is to use the tuner's audio transmission ability (described in the next paragraph)to broadcast the audio signal within your car directly to the radio via FM modulation. Transmitting audio to your car radio This tuner system is able to transmit the audio signal to your car radio in the FM radio spectrum. By tuning your radio to a corresponding channel, you can listen to the audio from your program source. This function is particularly important when installing in car whose radio lacks AUX line level inputs. [. . . ]