User manual PYLE PLVW65M

[. . . ] MENU 5. TV/AV/AUTO 6. CHANNEL+ 7. CHANNEL8. VOLUME+ 9. VOLUME- 10. REMOTE Jack 15. DIVERSITY ANTENNA 16. DC 12V Input Jack 17. S-VIDEO Jack 18. AV IN Jacks FIG. A 6. 5 inch color TFT Monitor 4 LOCATION AND FUNCTION OF KEYS 1. [. . . ] You can connect earphone to any one of the jacks to receive sound signal. REMOTE Through the REMOTE jack (14), connect DVD unit or anther unit to the monitor. Then you can control the DVD unit or anther unit by pointing the remote control handset directly to the remote sensor IR (3). DIVERSITY ANTENNA There are four jacks (15) for diversity antenna input. This diversity antenna system allows four different TV RF signal input, and it can select one of the highest level of electrical filed strength automatically. DC 12V INPUT JACK Through this jack (16), provide DC 12V power supply to the unit. S-VIDEO JACK The jack (17) is used for S-VIDEO input. AV INPUT JACK The group of jacks (18) is used for VIDEO in, AUDIO R in and AUDIO L in. 6 TROUBLE SHOOTING Before going through the checklist, check wiring connection. If any of the problems persist after checklist has been made, consult your nearest service dealer. NO POWER Check if the power button on the front of the monitor is set to on. Check if the wires of DC power plug are properly connected. Check if there is power at the power supply outlet. THE PICTURE IS OVER DARK, OVER BRIGHT OR HAS NO COLOR: Press MENU button on the front of the unit, then press VOLUME+ button or VOLUME- button to increase or decrease the level of the corresponding item (BRIGHT, CONTRAST, COLOR or TINT) to proper value, then you can get an optimum picture effect. NO SOUND Check if the audio connections are properly connected. Check if the volume is minimum, and press the VOLUME+ button to increase the volume level. CAN'T RECEIVE TV SIGNAL OR THE PICTURE QUALITY IS POOR IN TV MODE: Please confirm if the antenna is connected to the antenna socket of the unit. [. . . ] Before installing the tray, stick the smaller quadrate sponge (a) to the tray and stick the larger quadrate sponge (b) to the inner side of the fastener according to the arrow in the figure below, Doing this can ovoid scraping the steel ripple pipe. (10)Sponge (a) (10)Sponge (b) (7)Fastener (8)Fix bolt (9)Tray 11 INSTALL THE TV DISPLAY UNIT OR THE CAMERA 1. INSTALL THE TV MONITOR Insert the position clip screw (5) into the hole on the tray, then insert the circular sheet of the position clip screw (5) to the position plate (referring to the " ADDITIONAL MATERIAL EXPLANATION" below) on the bottom of the TV monitor and rotate the clip screw (6) to the screw of the position clip-screw(5) from underside to fix the TV monitor to the tray. Position plate (5)Position clip-screw (6)Clip screw 2. [. . . ]